MacBook Air: Cannot select Ethernet during Setup Assistant
After you start up your MacBook Air for the first time and connect a USB Ethernet adapter during the Setup Assistant, the Setup Assistant may not allow you to select Ethernet to transfer your information from another Mac or to configure your Internet connection.
Anyone running Lion on their Mac?
I'm currently running Snow Leopard (v. 10.6.8) and have been hesitant to upgrade to 10.7.X.
Anyone at all running Lion? Any experiences good or bad to report?
Thanks! (7 Replies)
I am thinking to purchase a new MacBook Air, 13 inch.
Anyone have a MacBook Air? What do you think about it? Seems expensive, a bit. Is it worth it? (9 Replies)
KUE(4) BSD Kernel Interfaces Manual KUE(4)NAME
kue -- Kawasaki LSI KL5KUSB101B USB Ethernet driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device uhci
device ohci
device usb
device kue
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_kue_load="YES"
DESCRIPTION
The kue driver provides support for USB Ethernet adapters based on the Kawasaki LSI KL5KLUSB101B chipset.
The KL5KLUSB101B supports a 128-entry multicast filter, single perfect filter entry for the station address and promiscuous mode. Packets
are received and transmitted over separate USB bulk transfer endpoints.
The Kawasaki chipset supports only 10Mbps half-duplex mode, hence there are no ifmedia(4) modes to select.
For more information on configuring this device, see ifconfig(8).
HARDWARE
The kue driver supports Kawasaki LSI KL5KLUSB101B based USB Ethernet adapters including:
o 3Com 3c19250
o 3Com 3c460 HomeConnect Ethernet USB Adapter
o ADS Technologies USB-10BT
o AOX USB101
o ATen UC10T
o Abocom URE 450
o Corega USB-T
o D-Link DSB-650C
o Entrega NET-USB-E45, NET-HUB-3U1E
o I/O Data USB ETT
o Kawasaki DU-H3E
o LinkSys USB10T
o Netgear EA101
o Peracom USB Ethernet Adapter
o Psion Gold Port USB Ethernet adapter
o SMC 2102USB, 2104USB
DIAGNOSTICS
kue%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the
transmission before a timeout expired.
kue%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring.
SEE ALSO arp(4), netintro(4), ng_ether(4), ifconfig(8)HISTORY
The kue device driver first appeared in FreeBSD 4.0.
AUTHORS
The kue driver was written by Bill Paul <wpaul@ee.columbia.edu>.
BUGS
The kue driver does not accumulate Ethernet collisions statistics because the Kawasaki firmware does not appear to maintain any internal sta-
tistics.
BSD October 7, 2006 BSD
