Oracle's StorageTek T10000C tape drive is the first to offer the StorageTek Search Accelerator (SSA). SSA uses tape drive hardware to speed data searches, and offload that processing requirement from other data center resources.
Hi everyone,
I have a big problem and i hope u can help me. I have brand new sun server X4-2 with Solaris 10-update 10. I have to install oracle StorageTek but there is no guide or help on the internet. Can anybody help me?
CU (1 Reply)
Hi,
I recently got StoragaTek 2500 and I would like to connect it to my solaris machine, since I don't have much experience with storages, could someone point me how to do so, how can i present disks from storage on my solaris os? (everything is already connected)
thanks in advance (1 Reply)
I believe this may be a difference in GTK+-2.0 and GTK+-3.0. I followed this tutorial and ended up with this error:
# gcc -Wall -g mnemonics.c -o mnemonics `pkg-config --cflags gtk+-3.0` `pkg-config --libs gtk+-3.0`
mnemonics.c: In function ‘main':
mnemonics.c:44:61: error: ‘GDK_q' undeclared... (3 Replies)
Hello all !
I am a beginner about system and networking , and after some research on internet , i didn't find any relevant information , so i post here , if someone have an experience with this kind of material or if some documentation about how to connect my storage device on my server.
I... (2 Replies)
Hi,
I installed DirectFb on fedora 7, the machine has a Nvidia graphics card. The installation was successful and I can play the examples provided by the Direct fb website, but, I find that the accelarator is not getting recognised. when I do "fbset -i", the details shown are as below, it gives... (0 Replies)
I had been using a modem installed on a Digi accelerator port to dial in to an SCO open server r5 server. On monday it quit working and I realy don't know how it was installed and configured. I have tested the modem on a PC and it works. The port the modem is connected to is ttyB06 and I have... (1 Reply)
tms(4) Kernel Interfaces Manual tms(4)Name
tms - TMSCP magnetic tape interface
Syntax
For UNIBUS, Q-bus:
controller klesiu0 at uba0
controller uq0 at klesiu0 csr 0174500 vector uqintr
tape tms0 at uq0 drive 0
For MSI Bus:
adapter msi0 at nexus?
controller dssc0 at msi0 msinode 0
tape tms0 at dssc0 drive 3
For VAXBI:
controller klesib0 at vaxbi0 node 0
controller uq0 at klesib0 vector uqintr
tape tms0 at uq0 drive 0
controller aie0 at vaxbi? node?
controller bvpssp0 at aie0 vector bvpsspintr
tape tms0 at bvpssp0 drive 0
For MSI Bus:
adapter msi0 at nexus?
controller dssc0 at msi0 msinode 0
tape tms0 at dssc0 drive 0
For VAX CI/HSC:
adapter ci0 at nexus?
adapter ci0 at vaxbi? node?
controller hsc0 at ci0 cinode 6
tape tms0 at hsc0 drive 3
Description
Prior to Version 2.0, this device was referenced by tmscp(4).
The TMSCP driver provides a standard tape drive interface, as described in This is a driver for any controller that adheres to the Tape
Mass Storage Control Protocol (TMSCP). The TMSCP controllers communicate with the host through a packet-oriented protocol termed the Tape
Mass Storage Control Protocol. This driver also supports n-buffered reads and writes to the raw tape interface (used with streaming tape
drives). See for further details.
Tape Support
TK50, TK70, TF70, TU81, TU81e, TA78, TA79, TA81, RV20, TA90, TA90E, TA91
Diagnostics
All diagnostic messages are sent to the error logger subsystem.
FilesSee Alsomtio(4), nbuf(4), MAKEDEV(8), uerf(8), tapex(8)
Guide to the Error Logger
tms(4)