osf1 man page for socket

socket(2)							System Calls Manual							 socket(2)

NAME
       socket - Creates an end point for communication and returns a descriptor

SYNOPSIS
       #include <sys/socket.h>
       int socket  (	  int domain,	   int type,	  int protocol );

STANDARDS
       Interfaces documented on this reference page conform to industry standards as follows:

       socket():  XNS5.0

       Refer to the standards(5) reference page for more information about industry standards and associated tags.

PARAMETERS
       Specifies  the  communications  domain  in  which  a  socket is to be created.  The domain argument specifies the address family with which
       addresses specified in later socket operations should be interpreted.  The sys/socket.h file contains the definitions of the address  fami-
       lies.   Commonly  used families are: UNIX pathnames Internet addresses (IPv4) [Tru64 UNIX]   Internet addresses (IPv6) Specifies the seman-
       tics of communication. The sys/socket.h file defines the socket types.  The following types are supported:  Provides  sequenced,  reliable,
       two-way	byte streams with a transmission mechanism for out-of-band data.  Provides datagrams, which are connectionless messages of a fixed
       maximum length.	[Tru64 UNIX]   Provides access to internal network protocols and interfaces. This type of socket is available  only  to  a
       process	with  superuser  privilege.  Specifies a particular protocol to be used with the socket.  Specifying a protocol of 0 (zero) causes
       the socket() function to default to the typical protocol for the requested type of returned socket.

DESCRIPTION
       The socket() function creates a socket of the specified type in the specified domain.

       The socket() function returns a descriptor (an integer) that can be used in later system calls that operate on sockets.

       Socket level options control socket operations. The getsockopt() and setsockopt() functions are used to get and set  these  options,  which
       are defined in the sys/socket.h file.

RETURN VALUES
       Upon  successful  completion,  the  socket()  function  returns a nonnegative integer (the socket descriptor).  Otherwise, a value of -1 is
       returned and errno is set to indicate the error.

ERRORS
       If the socket() function fails, errno may be set to one of the following values: The process have not  have  appropriate  privileges.   The
       addresses  in  the  specified  address  family  are  not  available in the kernel.  The per-process descriptor table is full.  No more file
       descriptors are available for the system.  Insufficient resources were available in the system to complete the call.  The system was unable
       to allocate kernel memory to increase the process descriptor table.  The available STREAMS resources were insufficient for the operation to
       complete.  [Tru64 UNIX]	The process is attempting to open a raw socket and does not have superuser privilege.  The socket in the specified
       address family is not supported.  The socket type is not supported by the protocol.

RELATED INFORMATION
       Functions:  accept(2), bind(2), connect(2), listen(2), getsockname(2), getsockopt(2), recv(2), recvfrom(2), recvmsg(2), send(2), sendto(2),
       sendmsg(2), setsockopt(2), shutdown(2), socketpair(2)

       Standards: standards(5) delim off

																	 socket(2)