vpartition(5) File Formats Manual vpartition(5)
NAME
vpartition - display information about the Virtual Partition Command Line Interface
DESCRIPTION
This manpage gives a listing and brief description of the commands that are used to manage virtual partitions.
|
Command | Description
--------------+----------------------------------------------------------
vecheck | Check for virtual partition environment.
|
vparadmin | Modify virtual partition flexible administrative
| capability related attributes.
|
vparboot | Boot (start) a virtual partition.
|
vparcreate | Create a new virtual partition.
|
vpardump | Manage monitor dump files.
|
vparefiutil | Update EFI device paths of bootable disks in the
|
|
vparenv | Set vPars or nPars mode, ILM or CLM granularity in
| system firmware, or display current values of these
| settings. Itanium-based platforms only.
|
vparextract | Extract memory images from a running virtual partition
| system.
|
vparmodify | Modify an existing virtual partition.
|
vparreloc | Relocate the load address of a vmunix file, determine
| if a vmunix file is relocatable, or promote the scope of
| symbols in a relocatable vmunix file.
| PA-RISC platforms only.
|
vparremove | Remove (delete) an existing virtual partition.
|
vparreset | Send a hard reset (TOC) to a virtual partition.
|
vparresources | Description of virtual partition resources and
| their requirements.
|
vparstatus | Display virtual partition and available resources
| information.
|
vparutil | Get and set SCSI parameters for disk devices from
| a virtual partition. PA-RISC platforms only.
AUTHOR
was developed by the Hewlett-Packard Company.
SEE ALSO
vparadmin(1M), vparboot(1M), vparconfig(1M), vparcreate(1M), vpardump(1M), vparefiutil(1M), vparenv(1M), vparextract(1M), vparmodify(1M),
vparreloc(1M), vparremove(1M), vparreset(1M), vparstatus(1M), vparutil(1M), vparresources(5), vpmon(5).
vpartition(5)
