9 More Discussions You Might Find Interesting
I would need to do hard code of nxge0 nic to full duplex & 1000mbps. So that whenever solaris server come up after reboot. it will show full duplex & 1000mbps setting only.
Please also let me know how to do it online through command.
regards (0 Replies)
Discussion started by: amity
I want a solaris zone,wich can get ip from dhcp external server
i configure my zone
address not specified
allowed-address not specified
defrouter not specified
vnic is linked to net0
net0 ... (6 Replies)
Discussion started by: Linusolaradm1
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
My nic is detected in linux... (0 Replies)
Discussion started by: vectrum
4. UNIX for Dummies Questions & Answers
Right now I have a computer that I want to use as the monitor for my network. It's currently running Windows 7, and so as I understand it the NIC won't monitor all the traffic on the network. So my question is, if I install Linux on this computer will I be able to force the NIC card into... (1 Reply)
Discussion started by: iJeydon
5. IP Networking
I have a TOSHIBA AS7000 B150 Sun Box
I wanted to run it with 100M/full duplex
I had added this to the /etc/system file to make to setting permenant So it would be set correctly on reboot.
But when I... (4 Replies)
Discussion started by: AirWalker83
I need to change some Ip addresses for my servers to reflect in the NIS map.
I also need to force full duplex on the 10/100 cards & 1/2 duplex in the 10 cards.
I can change the IP by doing ifconfig <NIC card > plumb up <newip>.
Not quite sure on how to force the full / half duplex & how to... (2 Replies)
Discussion started by: Remi
7. Red Hat
I have a RedHat 9 box which I need to figure out how to get it to stay in full duplex mode after a reboot.
I have tried
ethtool -s eth0 speed 100 duplex full autoneg off
I have tried to add a line to the /etc/sysconfig/network-scripts/ifcfg-eth0 like this:
ETHTOOL_OPTS="speed... (4 Replies)
Discussion started by: bubba112557
I tried to use this command
ndd -set /dev/eri adv_1000fdx_cap 1
but i get a "operation failed, Invalid argument"
anyone can help ? Thanks (5 Replies)
Discussion started by: DarReNz
9. UNIX for Advanced & Expert Users
Does any body knows how to force NIC to 100 Full Duplex in Solaris 8, should survive after reboot or shutdown. (1 Reply)
Discussion started by: s_aamir