10 More Discussions You Might Find Interesting
1. AIX
Friend's,
I was playing around with NIM in my environment & had a quick question in mind which I didn't/couldn't find answer to, which is -- how to find the name of the NIM server sitting on the NIM client?
All leads to the answer would be much appreciated, many thanks!
-- Souvik (2 Replies)
Discussion started by: thisissouvik
2 Replies
2. AIX
Hello, I have an AIX6.1 machine which is a nim client to my nim master which is also AIX6.1 machine. I had some problem to perform an installation on my client using smit nim . i removed /etc/niminfo file in order to do the initialization again but when i run the command niminit -a name=client... (0 Replies)
Discussion started by: omonoiatis9
0 Replies
3. AIX
Hi.
I change my client's IP and hostname but I forgot to change anything on the master. How can I redefine or modify my client's resource from my master, or with using smit niminit from my client ?
Tks (2 Replies)
Discussion started by: stephnane
2 Replies
4. AIX
Hello everyone
Im trying to backup a nim client from nim master but I got this message
COMMAND STATUS
Command: failed stdout: yes stderr: no
Before command completion, additional instructions may appear below.
0042-001 nim:... (2 Replies)
Discussion started by: lo-lp-kl
2 Replies
5. AIX
Hello All,
I believe my NIM master is fine. lsnim and cat /etc/niminfo gives me the right output. While doing "lsnim" on a client machine, I get ksh:lsnim:"not found".
Please someone be nice enough to explain what are the steps to verify the master and client connectivity to do all the NIM... (3 Replies)
Discussion started by: solaix14
3 Replies
6. AIX
Hello everyone
I have two questions.
1.-The NIM and EZNIM are the same.
2.-If I have in one partition NIM installed I need to install EZNIM or I need to unistall NIM and then install EZNIM.
Thanks for your comments. (2 Replies)
Discussion started by: lo-lp-kl
2 Replies
7. AIX
Hello guys,
what is a sure-shot single command to find out if the NIM environment is working properly from both master as well as client side? (2 Replies)
Discussion started by: solaix14
2 Replies
8. AIX
Hi,
I'm getting the above error while trying to take a MKSYSB image via NIM. I've only just started getting this and don't know why it is failing.
Any one got any suggestions?
Thanks
Kees (3 Replies)
Discussion started by: KeesH
3 Replies
9. AIX
I try to migrate a NIM server from one server to another.
I try to do a mksysb on NIM server
restore the NIM server's mksysb to a client through NIM installation
shutdown NIM server
start newly installed client as NIM server
Does anyone do this before? who can give me some suggestion? (1 Reply)
Discussion started by: yanzhang
1 Replies
10. AIX
Hi Guys..
Got a NIM issue.. Am trying to pull a image of a client from NIM server.
am getting the following error... in standard error output..
0042-001 nim: processing error encountered on "master":
Usage: rm File...
Am using the same script to pull image and it works fine..... (1 Reply)
Discussion started by: balaji_prk
1 Replies