MALO(4) 						   BSD Kernel Interfaces Manual 						   MALO(4)

NAME

     malo -- Marvell Libertas IEEE 802.11b/g wireless network driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device malo
	   device pci
	   device wlan
	   device firmware

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   if_malo_load="YES"

DESCRIPTION

     The malo driver provides support for Marvell Libertas 88W8335 based PCI and Cardbus network adapters.  malo supports station and monitor mode
     operation.  Only one virtual interface may be configured at any time.  For more information on configuring this device, see ifconfig(8).

     This driver requires the malofw firmware kernel module be installed before it will work.  The firmware files are not publicly available.  A
     port of the firmware can be found at:

	   http://weongyo.org/project/malo/malo-firmware-1.4.tar.gz

     The firmware kernel module can be installed by extracting the archive and running 'make install clean' in the malo-firmware-1.4 directory.

     To load the malofw firmware kernel module at boot time, place the following line in loader.conf(5):

	   malofw_load="YES"

HARDWARE

     The following cards are among those supported by the malo driver:

     Card		Chip	   Bus	  Standard
     Netgear WG311v3	88W8335    PCI	  b/g
     Tenda TWL542P	88W8335    PCI	  b/g
     U-Khan UW-2054i	88W8335    PCI	  b/g

EXAMPLES

     Join an existing BSS network (i.e., connect to an access point):

	   ifconfig wlan create wlandev malo0 inet 192.168.0.20 
	       netmask 0xffffff00

     Join a specific BSS network with network name ``my_net'':

	   ifconfig wlan create wlandev malo0 ssid my_net up

     Join a specific BSS network with 64-bit WEP encryption:

	   ifconfig wlan create wlandev malo0 ssid my_net 
		   wepmode on wepkey 0x1234567890 weptxkey 1 up

SEE ALSO

     cardbus(4), pci(4), wlan(4), wlan_ccmp(4), wlan_tkip(4), wlan_wep(4), ifconfig(8), wpa_supplicant(8)

HISTORY

     The malo device driver first appeared in FreeBSD 7.1.

BSD
								September 20, 2014							       BSD