05-05-2005
The only thing it could be is the mother board if the memory works fine in the other server.
4 More Discussions You Might Find Interesting
1. Solaris
Hello,
I wrote a script which monitor the keyswitch state repeatedly each 10 minutes.
I'm extracting the keyswitch status by using prtdiag.
The script works fine for Netra v440 , but I found that prtdiag under Netra 1290 don't give keyswitch status.
unlike Netra 440 server , I found that... (2 Replies)
Discussion started by: Alalush
2 Replies
2. Solaris
Looking for ideas on why I can't dial into our new Avaya CMS server (Sun Netra 210 - Sol 9) - remotely thru our ASA - site admin software.
Running R3-V13 Avaya CMS software - just did a fresh install of the CMS software - install went perfect.
The Sun supplied DB9 connector is installed... (1 Reply)
Discussion started by: drewmich
1 Replies
3. Solaris
Hi,
I have a netra t2000 running solaris 10. It is fully patched with the latest patch cluster and also patch 118833-36 and 126897-02. The SC sys_event level is set to 3.
I am running a test to show hardware log status, e.g simulating a power supply failure.Hence I unplug one of te... (3 Replies)
Discussion started by: ulemsee
3 Replies
4. Solaris
hey guys i'm in university and i bought my self a sun ultra SPARC netra 500mhz machine with the usb ports a vga gfc and cdrom drive
now i have a problem (bought it off ebay) i trying to install a fresh solaris 10 server op onto it but it looks like it previously had linix installed and... (38 Replies)
Discussion started by: garethmob
38 Replies
LEARN ABOUT DEBIAN
freecell-solver-range-parallel-solve
HOOLA(6) Freecell Solver HOOLA(6)
NAME
freecell-solver-range-parallel-solve - The Freecell Solver utility for solving a range of Microsoft Freecell/Freecell Pro Boards
SYNOPSIS
freecell-solver-range-parallel-solve start end print_step [--binary-output-to filename] [--total-iterations-limit limit] [fc-solve
Arguments...]
DESCRIPTION
freecell-solver-range-parallel-solve is a command line application that solves a range of Freecell deals of Microsoft Freecell and Freecell
Pro.
start is the first board to solve; end is the last (inclusive) and print_step is the division of board numbers in which to print a status
message.
Following this three mandatory parameters are several flags specific to the range solve. (refer to the OPTIONS section for more
information)
Afterwards one can give it a fc-solve command line that it will use to solve each board. Refer to the fc-solve(6) man page for information
about its options.
OPTIONS
--total-iterations-limit sets the maximal number of iterations with which to try to solve each deal. After that, the program will give up
and report that the board was intractable.
--binary-output-to sets the filename into which to output the number of iterations it took to solve each board. This file can later be used
with statistical preset optimizers such as those found in the Freecell Solver version control repository.
SEE ALSO
fc-solve(6)
AUTHOR
Shlomi Fish, <http://www.shlomifish.org/> .
Freecell Solver 3.12.0 2012-06-22 HOOLA(6)