Sponsored Content
Special Forums IP Networking Quick Poll: Solaris IP Multipathing Post 44390 by RTM on Friday 5th of December 2003 08:57:18 AM
Old 12-05-2003
I have never seen it set up on any servers - but then again, most of the servers were running Solaris 2.6 or did not have the hardware.

It is being implemented in other parts of the company I work for - (different areas have different ideas of what should be done). Or at least it is known and suggested.

I think it's not out there much because you don't normally get failures on interface cards. If the failure rate was higher, then it would be used more. I've seen more cables go bad than cards (due to clumsy people) and it's normally fixed at the same time it was broken. I can't remember the last time a system was down due to an interface card.
 

7 More Discussions You Might Find Interesting

1. Solaris

Quick question about Solaris =)

:D Just curious, I know that solaris 2.0-2.x_present are System V UNIX... But, I have only used Solaris 10, 9 and 2.5... On a 2.5 Sparc box, after you login you get presented with the usual SunOS 5.5.1 then UNIX(R) System V Release 4.0 I know Solaris 9 and 10 do not include this banner... ... (0 Replies)
Discussion started by: ssorel
0 Replies

2. Solaris

solaris multipathing

I have solaris 10 sparc. I installed a Qlogic hba card. This card is connected on a brocade switch and the brocade is connected on 2 different controllers on a Hitachi disk bay. I formated 2 luns. On my solaris system, i have 4 disk. How to configure solaris 10 to fix the dual disk view. ... (4 Replies)
Discussion started by: simquest
4 Replies

3. Solaris

Solaris IP Multipathing (IPMP) Help

Hello All, I work for a Health care company at a local trauma hospital. I maintain a Picture Archiving and Communication System (PAC's). Basically, any medical images (X-Ray, CT, MRI, Mammo, etc) are stored digitally on the servers for viewing and dictation from diagnostic stations. I took over... (10 Replies)
Discussion started by: mainegeek
10 Replies

4. Solaris

Solaris IP Multipathing

Hi, I saw your post on the forums about how to setup IP multipathing. I wanted your help on the below situation . I have 2 servers A and B . Now they should be connected to 2 network switches . S1 and S2. Now is it possible to have IP Multipathing on each of the servers as follows ? ... (0 Replies)
Discussion started by: maadhuu
0 Replies

5. Solaris

Disable Inbuilt multipathing software of Solaris 10

Dear UNIX Gurus I need to know how to disable MPXIO feature (Inbuilt multipathing software of Solaris 10) as we are going to implemented iSCSI EMC based SAN. I am bit new to this feature so kindly suggest how to disable it Regards (4 Replies)
Discussion started by: girish.batra
4 Replies

6. Solaris

Solaris multipathing

Hai we using emc storage which is conneted to M5000 through san switch. we asign 13 luns but in server it is showing 22 luns. i enable the solaris multipathing (MPxIO) #more /kernel/drv/fp.conf in that file MPxio-disable=no #mpathadm list lu it shows ... (2 Replies)
Discussion started by: joshmani
2 Replies

7. Solaris

ZeusIOPS multipathing failed Solaris 11

hi, just installed solaris 11.1 (11.1.9.5.1) on a sun7410 ZFSSA (x4440 + j4400), but when I enable multipathing with "stmsboot -e", only the 1TB SATA drives inside the j4400 are configured as multipathed vhci / mpxio devices, but the logzillas / ZeusIOPS drives are skipped. the server is... (0 Replies)
Discussion started by: pressy
0 Replies
FISH(6) 							 BSD Games Manual							   FISH(6)

NAME
fish -- play ``Go Fish'' SYNOPSIS
fish [-p] DESCRIPTION
fish is the game ``Go Fish'', a traditional children's card game. The computer deals the player and itself seven cards, and places the rest of the deck face-down (figuratively). The object of the game is to collect ``books'', or all of the members of a single rank. For example, collecting four 2's would give the player a ``book of 2's''. The options are as follows: -p Professional mode. The computer makes a random decision as to who gets to start the game, and then the computer and player take turns asking each other for cards of a specified rank. If the asked player has any cards of the requested rank, they give them up to the asking player. A player must have at least one of the cards of the rank they request in their hand. When a player asks for a rank of which the other player has no cards, the asker is told to ``Go Fish!''. Then, the asker draws a card from the non-dealt cards. If they draw the card they asked for, they con- tinue their turn, asking for more ranks from the other player. Otherwise, the other player gets a turn. When a player completes a book, either by getting cards from the other player or drawing from the deck, they set those cards aside and the rank is no longer in play. The game ends when either player no longer has any cards in their hand. The player with the most books wins. fish provides instructions as to what input it accepts. BUGS
The computer cheats only rarely. BSD
May 31, 1993 BSD
All times are GMT -4. The time now is 06:44 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy