Sponsored Content
Full Discussion: suse 9.0 problem video
Top Forums UNIX for Dummies Questions & Answers suse 9.0 problem video Post 44087 by iGZo on Saturday 29th of November 2003 11:05:58 PM
Old 11-30-2003
I have seen this problem posted elsewhere, assuming this is the same "issue", simply plug your monitor's cable into the onboard video, or the AGP card still installed. The issue is that the "should be-BIOS-disabled onboard-video adaptor" is still being intialized at boot, and it ends up the default video for X, and friends. VMware uses an emulated video adaptor, which is a very common one, and boots normally because it will only see the one video "card" the VM is providing. Just a thought.
 

10 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

Just a video problem

Heya, pals! Would someone give me a clue of whatīs happening in here? I have a SiS 6326 video board installed under a FreeBSD 4.2 system, but i canīt figure out whatīs the matter with its configuration. I just canīt connect to Xserver... Setting the configuration with xf86config at the simplest... (1 Reply)
Discussion started by: Z0mby
1 Replies

2. UNIX for Dummies Questions & Answers

SuSE 8.1 NIC problem

i have just installed suse 8.1 on a third computer which has an Asus p4s8x with onboard NIC and sound. now, on install suse detected everything automatically with no probelm, however upon reboot the sound failed to load as well as the network card. /dev/eth* doesnt exist. i looked in the bios and... (2 Replies)
Discussion started by: norsk hedensk
2 Replies

3. UNIX for Dummies Questions & Answers

Laptop video problem....

I am running freeBSD on a Digital (company before compaq) laptop, and it is not displaying properly. there is about 2 inches on all sides of the screen that the display doest stretch to, its a little box in the center of the screen, anyone know how i can fix that problem?? any help would be much... (4 Replies)
Discussion started by: MadProfessor
4 Replies

4. SuSE

Setup Problem with SUSE Linux

I setup SUSE Linux 10. I downloaded from SUSE website. A DVD version. But I have a problem: Please click to see the screen shots Shot 1: (Problem is here, with Software) http://www.vernoos.net/shot-1.jpg Shot 2: http://www.vernoos.net/shot-2.jpg Shot 3:... (1 Reply)
Discussion started by: HASSELBLAD
1 Replies

5. SuSE

SuSE parted problem

Hello, So, I burned the 5 cds of SuSE 10.1, and would really like to begin installation. But when I get to the partitioning phase, I get an error message saying the first hard drive is unreadable by parted, and that I'll have to use Yast instead. It also tells me I wont be able to move delete... (0 Replies)
Discussion started by: Mudrack
0 Replies

6. SuSE

GUI problem with Suse Linux

hi Guys,, Am very new to Linux OS.. This is my first experience with Linux. I have installed linux suse 10 in my laptop.it was working fine.. suddenly after 3 days,(i was changing some options of the already installed linux) when i login, i am getting only command interface and GUI is not... (2 Replies)
Discussion started by: mac4rfree
2 Replies

7. SuSE

problem of readdir on IA64 suse

Dear Experts, i am trying to find whether the given name is file or a directory dirp = opendir(dirname); direntp = readdir(dirp); if(direntp->d_type & DT_DIR) { printf("\n is a dirctory"); } else { //dir_or_file = Mtrue; printf("\n not a directory"); } it always... (9 Replies)
Discussion started by: vin_pll
9 Replies

8. Filesystems, Disks and Memory

RAID Problem on SUSE 11.0

I setup a RAID 5 with 5 drives, one failed, hardware failure so I physically removed it from the raid after powering the machine off then powered it back on and my raid was still good but no 5th drive. I built a 5th drive from scratch and added it in the raid thinking the raid would go into... (0 Replies)
Discussion started by: lacakid
0 Replies

9. UNIX for Dummies Questions & Answers

Suse Linux 11.4 networkmanager problem

I am a newbie to Suse linux and was trying to configure internet on my 11.4 suse linux system . I followed a post according to which i uninstalled my NetworkManger library . Later i realised that the real reason for wireless not working on my system was that my wireless driver firmware was... (0 Replies)
Discussion started by: ihatetoregister
0 Replies

10. UNIX Desktop Questions & Answers

Suse Linux enterprise 10 - booting problem

Hi, It was happened to close my laptop without proper shutdown due to power failure with USB device connected to it. (removed the USB after shut down) After this incident, I was not able to boot my suse linux OS. Initial study reveals that the device is not unmounted properly and shows... (2 Replies)
Discussion started by: Prabhu V
2 Replies
XvQueryAdaptors(3)						  libXv Functions						XvQueryAdaptors(3)

NAME
XvQueryAdaptors - return adaptor information for a screen SYNOPSIS
#include <X11/extensions/Xvlib.h> int XvQueryAdaptors(Display *dpy, Window window, unsigned int *p_num_adaptors, XvAdaptorInfo **pp_adaptor_info); ARGUMENTS
dpy Specifies the connection to the X server. window Specifies a window of the screen for which the adaptor information is desired. p_num_adaptors A pointer to where the number of adaptors for the specified screen is returned. pp_adaptor_info A pointer to where the list of returned adaptor information is returned. DESCRIPTION
XvQueryAdaptors(3) returns an video adaptor information for the screen of the specified drawable. The XvAdaptorInfo structure has the following organiza- tion: typedef struct { XvPortID base_id; unsigned long num_ports; char type; char *name; unsigned long num_formats; XvFormat *formats; unsigned long num_adaptors; } XvAdaptorInfo; base_id The resource ID of the first adaptor port. num_ports The number of ports supported by the adaptor. type A bit mask with the value XvInputMask asserted if the adaptor supports video input, and value XvOutputMask asserted if the adaptor supports video output. In Xv protocol 2.2 and later, there are 3 new bits defined - XvVideoMask, XvStillMask and XvImageMask indi- cating that the adaptor is capable of video, still or image primitives respectively. name A vendor specific name that identifies the adaptor. num_formats The number of depth/visual id formats supported by the adaptor. formats A pointer to an array of XvFormat structures. The XvFormat structure has the following organization: typedef struct { char depth; unsigned long visual_id; } XvFormat; depth A drawable depth supported by the adaptor. visual_id A visual-id supported for the given depth by the adaptor. RETURN VALUES
[Success] Returned if XvQueryAdaptors(3) completed successfully. [XvBadExtension] Returned if the Xv extension is unavailable. [XvBadAlloc] Returned if XvQueryAdaptors(3) failed to allocate memory to process the request. DIAGNOSTICS
[Drawable] Returned if the requested drawable does not exist. SEE ALSO
XvFreeAdaptorInfo(3) X Version 11 libXv 1.0.7 XvQueryAdaptors(3)
All times are GMT -4. The time now is 04:53 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy