Still sorting out the laws and regulations in Thailand, which recently changed (yet again).
It seems we can transmit more power at 923 MHZ than at 433 MHZ (and other regulatory requirements are different), so even though the lower frequency tends to penetrate better, word has it here that the extra output power permitted here makes 923 a better choice. However, I'm not convinced either way and it may be device, chipset dependent.
I'll probably test all . (433 and 923 MHZ), because I am also going to experiment with some M5Stacks with LoRa as well.
Hi all...
(Apologies for any typos at all.)
This is a step by step _script_ to check if your Arduino is talking to your Linux or Macbook Pro computer using the Terminal...
It works on at least 3 Linux flavours and now the Macbook Pro...
I hope you find it useful as a simple check for... (0 Replies)
This is a very simple starter DEMO to access Arduino Diecimila Board for the
Macbook Pro 13" OSX 10.7.5...
A potentiometer is connected between 5V and Gnd with the wiper connected to
ANALOG IN 0 on the Arduino. This was adjusted to give the Ms and Ls as seen...
I now have DC in for this... (0 Replies)
I am working on a semi-auto detection idea for Arduino for the Scope project.
It does require a little user intervention but minimal.
It works by just responding to two on screen prompts to unplug and plug Arduino
into a USB port.
There are two versions and both work perfectly well and give... (3 Replies)
In my further exploration of Arduino, today I decided to install the arduino-cli on my mac today.
https://github.com/arduino/arduino-cli
I followed the instructions for macOS but when I got to this part:
arduino-cli board list
I got the dreaded "Unknown" Fully Qualified Board Name... (1 Reply)
HI all...
(Apologies for any typos.)
To add to Neo's Arduino subject matter I have decided to upload this in ".zip" format.
Ignore "*.info" files these are AMIGA icons only and also the "HAM" drawer as these are photos in ancient AMIGA HAM modes.
I have noticed that there are current... (6 Replies)
Just finished a quick Python script to send the current unix time over to the Arduino from macOS, so in the absence of GPS or some other way to get the unix timestamp (epoch time) to the Arduino, I can get my macOS and Arduino UNO synced to within a second.
Normally, when the Arduino starts... (9 Replies)
Today I received my NB-IoT Arduino Shield for AIS (Thailand). Here is a "pinout" photo of the shield.
My shield looks just like the one above, for the most part. I'll post another photo of the actual device later.
When I received the shield in the mail, I went immediately to a local... (8 Replies)
Yesterday I had a chance to enjoy testing LoRaWAN with the owner of the M2M Shop who was kind enough to drive three hours down the seacoast to set up and test the Dragino LoRaWAN LG308 gateway operating on AS923MHz in Thailand.
Ahead of K. Somsak's visit, he had asked me to install Thonny,... (0 Replies)
This post describes a "work in progress" project I started today. Here is the High Level Overview:
Currently, this project sits on my desk as an Arduino UNO (on the bottom), an NB-IoT Shield (sandwiched in the middle), a Sensor Shield (on top) with a HM-10 BLE Module (in the little... (13 Replies)
Normally I'm not into kits, but I thought my wife would enjoy this one since she is a big fan of robots and droids on StarWars!
We are done with the basic mechanical assembly and starting on the electronics assembly today.
The robot's "brain" consists of three levels. The Arduino board, on... (5 Replies)