Configuring NIC device in Solaris 9 SPARC OS [QEMU]
I have Xubuntu 18.04 installed on my PC. I have created a 10G .img image file created by QEMU-IMG. I have installed inside of it Solaris 9 SPARC edition [GUI interface]. If I try and mount the image file as a loop device (using sudo losetup /dev/loop0 /path-to-img-file) I can only mount it as read only.
When I type in dmesg into terminal I am informed that the UFS kernel has been compiled in read-only support.
I investigated into this and found that the Linux UFS kernel is compiled to be as such (read only for UFS) as there has been data loss issues when mounting UFS file systems as read,write in the past. Therefore I need to setup an internet connection within Solaris 9 through the QEMU VM I know about editing the following configuration files ...
But what I am struggling to do is locate and/or install the driver for my NIC card on my mounted Solaris 9 OS and activate it (ifconfig XXPUT-NIC-DEV-HEREXXX up ) If I can do that then I can get down to business on the conf files above.
Can anyone help? I shall gladly await your response
regards
Hi.
I have HP-9000 Server running HP-UX 10.20. rECENTLY OUR network upgraded to 100mb/sec and I want to do same on the server. So, I add the second Network card (100MB). But the problem is, I can't find a way of configuring this card. How am i going to tell the server to use this 100mb card... (1 Reply)
Hi ......
I'm trying to configure my Solaris servers with only one NIC card to have 2 IP addresses as well as 2 different default gateways.
( NOT to be confused with multi-pathing - with 2 physical IPs & 1 virtual ip)
Thanks,
Remi (1 Reply)
Old DG box Aviion PentiumPro running R4.20Mu06 being used to try to recreate Ingres db from backup tapes so machine has not been operational before and some of original files in /etc may have ben overwritten
Unable to get NIC working
Any pointers on how to go about configuring NIC :rolleyes: (0 Replies)
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
attach?
My nic is detected in linux... (0 Replies)
Dear All
I want tune my NIC's rps, rfs and xps value.
In my system I have two NIC (eth0, eth1) and I have a bond0 ( eth0, eth1).
Here is the question? Which device should I modify ?
eth0 and eth1? or just modify bond0 or modify all device (eth0, eth1, bond0)
Any advice is welcome.... (0 Replies)
I have a Oracle SPARC server with Solaris SPARC 10 OS installed
I have a domestic router/modem box from my ISP in my house. I have a wifi extender in my room which has a RJ45 female socket for ethernet connection. The Wifi extender is configured properly to act as a bridge for machines to... (5 Replies)