I'm new with UNIX, i have a pseries server from IBM and i need to install AIX 4.3, i never used wyse terminal or AIX, i need help to know how to install it, i have the server and the wyse i get in into the aixterm, over com1 but i don't know wich command use or what to do to install it..... ... (0 Replies)
Hi All --
I have an old 7028-6C1 which I'm using to learn AIX. The system didn't include a graphics card, so I connected via the serial port and performed a fresh install of AIX 5L V5.3.
Later, I purchased a GXT135P (2849) graphics card, and added it to the system. When I ran diag, I was able... (2 Replies)
Hello Gurus,
i'm quite new person in AIX world, actually i'm SAP consultant. But due to my job faced with AIX.
Trying to configure new server for installation SAP. We have 4 disks one of them (hdisk3) has VG rootvg. How i can extend rootvg with another disk?
i tried:
# extendvg rootvg hdisk0... (2 Replies)
Anyone can help me answer the question.
Why does they use Linux on IBM pSeries not AIX.
I can't understand why, cause AIX is the best supporting from IBM pSeries.
Tks you. (3 Replies)
Hi ,
I am planing to buy IBM pSeries Power5 9111-285 1,9 GHz but I am confused with few things. I would be happy if you could clear it up for me ?
1.Do I have to buy some license in order to create Lpars ?
2.Do I have to buy some license in order to use HMC , micro - partiocioning , VIOS... (4 Replies)
Hello,
I installed PowerVM IVM Virtual I/O on P-550 but later found out that the machine isn't activated for CoD VET code for virtualization.
So when booted , it goes into OPEN Firmware
I/O Hosting requires a hosting partition boot not permitted exit called
> ok
Panel shows > IO... (3 Replies)
Hidey Ho Folks,
Looking to buy a pServer for playing around with the IBM side of things. Looked around for a bit and notice that there is a significant price gap for the used 570's (Single Units) vs the 520's and 550's that folks are selling. Curious what to watch out for in either case? And... (6 Replies)
Hello,
I'm very rookie to AIX and attempting to install AIX. I have vio ready on the machine and don't know how to install OS? Inserted Volume 1 DVD into the ROM, don't know what to do next. Searched many forum but cant find the this basic thing. Please let me know how to install AIX on this... (4 Replies)
Hi There,
I have zero information and zero knowledge for IBM virtual machine except Amazon cloud and VMware ESXi (Only Linux OS available).
Anyone could provide me the following answer -
Can IBM VM been deploy on X86 and X64 (Intel Chip)?
If answer is yes any chance to deploy AIX OS... (13 Replies)
Discussion started by: chenyung
13 Replies
LEARN ABOUT NETBSD
adv
ADV(4) BSD Kernel Interfaces Manual ADV(4)NAME
adv -- ConnectCom Solutions AdvanSys SCSI adapter driver
SYNOPSIS
adv* at pci? dev ? function ?
adv0 at isa? port ? irq ? drq ?
adv* at cardbus? function ?
scsibus* at adv?
DESCRIPTION
The adv driver supports the following AdvanSys SCSI host adapters
PCI bus
Connectivity Products:
ABP920 Bus-Master PCI (16 CDB)
ABP930 Bus-Master PCI (16 CDB) (note 1)
ABP930U Bus-Master PCI Ultra (16 CDB)
ABP930UA Bus-Master PCI Ultra (16 CDB)
ABP960 Bus-Master PCI MAC/PC (16 CDB) (note 2)
ABP960U Bus-Master PCI MAC/PC Ultra (16 CDB) (note 2)
Notes:
1. This board has been sold by SIIG as the Fast SCSI Pro PCI.
2. This board has been sold by Iomega as a Jaz Jet PCI adapter.
Single Channel Products:
ABP940 Bus-Master PCI (240 CDB)
ABP940U Bus-Master PCI Ultra (240 CDB)
ABP970 Bus-Master PCI MAC/PC (240 CDB)
ABP970U Bus-Master PCI MAC/PC Ultra (240 CDB)
ABP940UW Bus-Master PCI Ultra-Wide (240 CDB)
Multi Channel Products:
ABP950 Dual Channel Bus-Master PCI (240 CDB Per Channel)
ABP980 Four Channel Bus-Master PCI (240 CDB Per Channel)
ABP980U Four Channel Bus-Master PCI Ultra (240 CDB Per Channel)
ISA bus
Connectivity Products:
ABP510/5150 Bus-Master ISA (240 CDB) (note 1)
ABP5140 Bus-Master ISA (16 CDB) (note 1) (note 2)
ABP5142 Bus-Master ISA with floppy (16 CDB) (note 3)
Notes:
1. This board has been shipped by HP with the 4020i CD-R drive. The board has no BIOS so it cannot control a boot device, but it can con-
trol any secondary SCSI device.
2. This board has been sold by SIIG as the i540 SpeedMaster.
3. This board has been sold by SIIG as the i542 SpeedMaster.
Single Channel Products:
ABP542 Bus-Master ISA with floppy (240 CDB)
ABP842 Bus-Master VL (240 CDB)
Dual Channel Products:
ABP852 Dual Channel Bus-Master VL (240 CDB Per Channel)
SEE ALSO cd(4), ch(4), intro(4), isa(4), pci(4), scsi(4), sd(4), st(4)
http://www.connectcom.net/
http://www.siig.com/
HISTORY
The adv device driver appeared in NetBSD 1.4.
AUTHORS
Baldassare Dante Profeta <dante@mclink.it>
BSD June 4, 1999 BSD