remove object(1m)														 remove object(1m)

NAME

       remove object - Removes a value from a set-valued or single-valued attribute (including application-defined attributes) of an object entry

SYNOPSIS

       cdscp remove object object-name attribute-name [= attribute-value]

ARGUMENTS

       The full name of the object entry.  The name of a particular attribute.	Specify only one attribute at a time.  See the cds_attributes file
       for the list of attributes and corresponding data types that your application uses.  The value of a particular attribute.  The value of	an
       application-defined attribute is dependent on the type of attribute.

DESCRIPTION

       The  remove  object  command  removes a value from a set-valued or single-valued attribute (including application-defined attributes) of an
       object entry.  If you do not specify a value, the command removes the entire attribute.	This command can delete attributes created by  the
       add  object and set object commands.  Usually, this task is performed through the client application.  See the OSF DCE Administration Guide
       for more information about attributes.

   Privilege Required
       You must have write permission to the object entry.

NOTE

       This command is replaced at Revision 1.1 by the dcecp command and may not be provided in future releases of DCE.

EXAMPLE

       To remove the value ps from  the  attribute  printcap  of  an  object  entry  named  /.:/mlh/deskprinter,  follow  these  steps:  Read  the
       cds_attributes file to check that the attribute printcap is listed, as shown in the following display:

	   OID		LABEL		 SYNTAX  1.3.22.1.3.50	  printcap	  char Enter the following command to remove the value ps from the
       attribute printcap.  cdscp> remove object /.:/mlh/deskprinter printcap = ps

RELATED INFORMATION

       Commands: add object(1m), list object(1m), set object(1m), show object(1m)

       Books: OSF DCE Administration Guide

																 remove object(1m)