BDFLUSH(2)						     Linux Programmer's Manual							BDFLUSH(2)

NAME

       bdflush - start, flush, or tune buffer-dirty-flush daemon

SYNOPSIS

       int bdflush(int func, long *address);
       int bdflush(int func, long data);

DESCRIPTION

       bdflush starts, flushes, or tunes the buffer-dirty-flush daemon.  Only the super-user may call bdflush.

       If func is negative or 0, and no daemon has been started, then bdflush enters the daemon code and never returns.

       If func is 1, some dirty buffers are written to disk.

       If  func  is 2 or more and is even (low bit is 0), then address is the address of a long word, and the tuning parameter numbered (func-2)/2
       is returned to the caller in that address.

       If func is 3 or more and is odd (low bit is 1), then data is a long word, and the kernel sets tuning parameter numbered (func-3)/2 to  that
       value.

       The set of parameters, their values, and their legal ranges are defined in the kernel source file fs/buffer.c.

RETURN VALUE

       If  func is negative or 0 and the daemon successfully starts, bdflush never returns.  Otherwise, the return value is 0 on success and -1 on
       failure, with errno set to indicate the error.

ERRORS

       EPERM  Caller is not super-user.

       EFAULT address points outside your accessible address space.

       EBUSY  An attempt was made to enter the daemon code after another process has already entered.

       EINVAL An attempt was made to read or write an invalid parameter number, or to write an invalid value to a parameter.

CONFORMING TO

       bdflush is Linux specific and should not be used in programs intended to be portable.

SEE ALSO

       fsync(2), sync(2), update(8), sync(8)

Linux 1.2.4							    1995-04-15								BDFLUSH(2)