Thanks for the reply. I actually resolved this yesterday.
The only way to do this was to first remove the cluster definition, because when volumes are part of a cluster resource group, you need to use cluster commands to make changes so the cluster is aware.
After removing the cluster definition I varied off the vg and exported the vg on both nodes. I could see the physical volume was still busy when trying to remove it, so I located the parent via:
Turns out the fiber adapter was keeping the volume busy, this adapter is also used for the rootvg so disabling wasn't an option. A reboot was required.
Following the reboot I was able to remove the volume and add the newly flashed lun. Lastly I redefined the cluster, tested, success.
hi all
we upgraded hacmp(powerha) from 5.2 to 5.4 recently .
during the failover testing, we found a strange network issue. after standby node took service ip address (172.15.100.8) online at standby NIC, we were able to log in the standby node by telnet 172.15.100.8 which stays at... (1 Reply)
Around a month ago we suffered a prolonged power outage, due to circumstances the servers and storage arrays were still in use when the UPS dropped. One of the servers was running a flash copy on the database while batch processing had commenced. This is the only server that suffered any further... (2 Replies)
Hi,
At first I have to say that I know nothing about Linux :(
But I am looking for solution how to copy one file from internal Lowrnace HDS flash memory.
Lowrance HDS is Linux based device.
Here is the link for firmware update files for this unit.
At the end of main firmware file there... (62 Replies)
I have noticed that when I copy files to flash disk and in UI I see message copy completed in notification area on task bar, usually copy is not completed. So, if I eject the media I loose data.
It is very serious problem because may cause loss of valuable and even critical data.
Moreover, when... (2 Replies)
hello
ive installed powerha 7.1.3 on two servers aix 6.1.9 6100-09-03-1415
work with dmx4 EMC storgae.
after sync cluster ( terminate with OK ) ive see that the repository disk upper only in one machine :
hdiskpower60 00c7f6b59fc60d9d caavg_private active... (1 Reply)
I have created a VxVM disk group in AIX7.1. I have tried to added this VxVM disk group in powerHA 6.1. But in cluster VxVM DGs are not listing. Is there any other procedure to add vxvm diskgroup to hacmp.
Please share me steps for adding vxvm diskgroup to hacmp. (6 Replies)
Hi All,
As per the IBM upgrade/support matrix
IBM Techdocs Technote: PowerHA for AIX Version Compatibility Matrix
we can't do online upgrade or rolling migration from powerha v7.1.0 to v7.1.3. on AIX61_TL9_SP4, So we are following the steps as below ...
1 ) Bring down the cluster
2 )... (2 Replies)