AMTAPE(8)						  System Administration Commands						 AMTAPE(8)

NAME

       amtape - Control Amanda changers

SYNOPSIS

       amtape [-o configoption...] config subcommand [subcommand_options...]

DESCRIPTION

       Amtape is the command-line interface to Amanda's tape changers (amanda-changers(7)) and to the taperscan algorithm (amanda-taperscan(7)).

       Tape changers maintain a notion of the current slot for each configuration. This may or may not correspond to an actual physical state of
       the device, but is used by some taperscan algorithms to minimize searching through the slots.

       Amtape uses the default changer. To use a different changer, use the config override option, e.g., -otpchanger=otherchanger.

SUBCOMMANDS

       label label
	   Search for and load the Amanda tape with label [label], also setting the current slot.

       slot slot
	   Load the volume in the given slot, also setting the current slot. The slot names current, next, first, and last have special meaning.

       current
	   Shorthand for slot current.

       inventory
	   Show the contents of all slots, based on the changer's cached metadata. This is a quick operation as it does not load or unload any
	   volumes, but is not supported by all changers.

       show [slots]
	   Show the contents of all slots (or listed slots) by loading each slot and reading its label. This can be very slow. The slots arguments
	   is of the form 1,3-5,7.

       reset
	   Reset the changer to a known state. This subcommand is intended to clear any unknown and potentially incorrect state the changer may
	   have stored.

       eject [drive]
	   Eject the tape currently in the drive. This only applies to some changers. Specify a drive (by drive number) if more than one drive is
	   available.

       clean [drive]
	   If a cleaning tape is defined for the changer, used it to clean the specified drive. The [drive] is optional if the changer only has
	   one drive.

       taper
	   Run the taperscan algorithm (see amanda-taperscan(7)), displaying information about the progress of the scan.

       update [what]
	   Update changer state. Consult amanda-changers(7) for changer-specific details on the format of what.

       -o configoption
	   See the "CONFIGURATION OVERRIDE" section in amanda(8).

SEE ALSO

       amanda(8), amanda-changers(7), amanda-taperscan(7), amanda-devices(7)

       The Amanda Wiki: : http://wiki.zmanda.com/

AUTHORS

       Dustin J. Mitchell <dustin@zmanda.com>
	   Zmanda, Inc. (http://www.zmanda.com)

       James da Silva <jds@amanda.org>

       Stefan G. Weichinger <sgw@amanda.org>

Amanda 3.3.3							    01/10/2013								 AMTAPE(8)