Hi, its giving me nothing. If I run just prtdiag -v it just listing DIMM slots, 0 On-Board devices and 3 upgradable slots with status available, Type - Unknown and Description - PCI-E Slot 1, PCI-E Slot 2, PCI-E Slot 3.
---------- Post updated at 10:24 AM ---------- Previous update was at 09:27 AM ----------
there wasn't installed netwrok drivers. Just installed drivers. Problem solved.
Yes. But just wait a bit. How to do it via system calls? I'm just a newbie in Unix\Linux\Solaris e.t.c. programming. Can anyone help me? I need an advice probably how to do it or may be what API to read... :) Please, help... (2 Replies)
Hi,
I am trying to configure an ip address, netmask, and default gateway on my solaris machine. For example, in Linux I would do the following command:
#ifconfig eth0 xx.xx.xx.xx netmask 255.0.0.0
#add route or route add default xxx.xxx.xxx.xxx
In Solaris 10, I believe the commands are... (7 Replies)
Hi,
I have problems with my SCO unix network interfaces.
Intel integrated adapter was failing, so I installed new one - 3COM adapter into free PCI slot.
Installed driver using SCO Software manager - successfully
Added new Network adapter using SCO Network configuration manager - successfully... (0 Replies)
Hi all, this is my first post on this forum. My main problem is this:
I have a NIM server that I am trying to configure two interfaces on. One interface is for an internal Admin VLAN, the other is so that the server can use SUMA to pull updates. The problem is that I need help w/ the routing.... (0 Replies)
Hi all, this is my first post on this forum. My main problem is this:
I have a NIM server that I am trying to configure two interfaces on. One interface is for an internal Admin VLAN, the other is so that the server can use SUMA to pull updates. The problem is that I need help w/ the routing.... (1 Reply)
I got second IOU in my M5000 but not able bring internal network interfcae .. ike i don't get link on those 2 interfaces .. and the same network cable plugged in PCI network card it works like a charm Is there any special way to enable the internal IOU interfaces or i have bad nics ? (8 Replies)
Hello
i am configuring a debian lenny sever ,/etc/network/interfaces is modified so that eth1 takes a static IP address
then i save it wq!
then i restart the networking , /etc/init.d/networking restart .
but after reboot ,the file is reset ,note that the interfaces had by defauklt IPv6 address... (5 Replies)
All, I have a quad NIC on a V880 running Solaris 9. I've heard you can bond interfaces together and get better throughput. I found this link that seems to describe the process well. However, the command mentioned (dladm) is missing. Is there some package I need to install to get this command? Thx.... (2 Replies)
i need a one liner command that writes in /var/log/net.log the date when i connect to the network and when i disconect ..i know that i need to write somethin in /etc/network/interfaces but idk what ! please help (1 Reply)
I just ran sudo service networking start on Ubuntu 16.00 and came out with error message
Job for networking service failed because control process exited with error code see systemctl status networking.service
I tried to also run this command
systemctl status networking.service
I also got an... (4 Replies)
Discussion started by: DOkuwa
4 Replies
LEARN ABOUT MOJAVE
systemd-networkd-wait-online.service
SYSTEMD-NETWORKD-WAIT-ONLINE.SERVICE(8) systemd-networkd.service SYSTEMD-NETWORKD-WAIT-ONLINE.SERVICE(8)NAME
systemd-networkd-wait-online.service, systemd-networkd-wait-online - Wait for network to come online
SYNOPSIS
systemd-networkd-wait-online.service
/lib/systemd/systemd-networkd-wait-online
DESCRIPTION
systemd-networkd-wait-online is a one-shot system service that waits for the network to be configured. By default, it will wait for all
links it is aware of and which are managed by systemd-networkd.service(8) to be fully configured or failed, and for at least one link to
gain a carrier.
OPTIONS
The following options are understood:
-i, --interface=
Network interface to wait for before deciding if the system is online. This is useful when a system has several interfaces which will
be configured, but a particular one is necessary to access some network resources. This option may be used more than once to wait for
multiple network interfaces. When used, all other interfaces are ignored.
--ignore=
Network interfaces to be ignored when deciding if the system is online. By default, only the loopback interface is ignored. This option
may be used more than once to ignore multiple network interfaces.
--timeout=
Fail the service if the network is not online by the time the timeout elapses. A timeout of 0 disables the timeout. Defaults to 120
seconds.
SEE ALSO systemd(1), systemd-networkd.service(8)systemd 237 SYSTEMD-NETWORKD-WAIT-ONLINE.SERVICE(8)