COMPRESS(1)						    BSD General Commands Manual 					       COMPRESS(1)

NAME

     compress, uncompress, -- compress and expand data

SYNOPSIS

     compress [-cfv] [-b bits] [file ...]
     uncompress [-cfv] [file ...]

DESCRIPTION

     The compress utility reduces the size of the named files using adaptive Lempel-Ziv coding.  Each file is renamed to the same name plus the
     extension ``.Z''.	As many of the modification time, access time, file flags, file mode, user ID, and group ID as allowed by permissions are
     retained in the new file.	If compression would not reduce the size of a file, the file is ignored.

     The uncompress utility restores the compressed files to their original form, renaming the files by deleting the ``.Z'' extension.

     If renaming the files would cause files to be overwritten and the standard input device is a terminal, the user is prompted (on the standard
     error output) for confirmation.  If prompting is not possible or confirmation is not received, the files are not overwritten.

     If no files are specified or a file argument is a single dash ('-'), the standard input is compressed or uncompressed to the standard output.
     If either the input and output files are not regular files, the checks for reduction in size and file overwriting are not performed, the
     input file is not removed, and the attributes of the input file are not retained.

     The options are as follows:

     -b      Specify the bits code limit (see below).

     -c      Compressed or uncompressed output is written to the standard output.  No files are modified.

     -f      Force compression of file, even if it is not actually reduced in size.  Additionally, files are overwritten without prompting for
	     confirmation.

     -v      Print the percentage reduction of each file.

     The compress utility uses a modified Lempel-Ziv algorithm.  Common substrings in the file are first replaced by 9-bit codes 257 and up.  When
     code 512 is reached, the algorithm switches to 10-bit codes and continues to use more bits until the limit specified by the -b flag is
     reached (the default is 16).  Bits must be between 9 and 16.

     After the bits limit is reached, compress periodically checks the compression ratio.  If it is increasing, compress continues to use the
     existing code dictionary.	However, if the compression ratio decreases, compress discards the table of substrings and rebuilds it from
     scratch.  This allows the algorithm to adapt to the next "block" of the file.

     The -b flag is omitted for uncompress since the bits parameter specified during compression is encoded within the output, along with a magic
     number to ensure that neither decompression of random data nor recompression of compressed data is attempted.

     The amount of compression obtained depends on the size of the input, the number of bits per code, and the distribution of common substrings.
     Typically, text such as source code or English is reduced by 50-60%.  Compression is generally much better than that achieved by Huffman cod-
     ing (as used in the historical command pack), or adaptive Huffman coding (as used in the historical command compact), and takes less time to
     compute.

DIAGNOSTICS

     The compress and uncompress utilities exit 0 on success, and >0 if an error occurs.

     The compress utility exits 2 if attempting to compress the file would not reduce its size and the -f option was not specified.

SEE ALSO

     gunzip(1), gzexe(1), gzip(1), zcat(1), zmore(1), znew(1)

     Welch, Terry A., "A Technique for High Performance Data Compression", IEEE Computer, 17:6, pp. 8-19, June, 1984.

STANDARDS

     The compress and uncompress utilities conform to IEEE Std 1003.1-2001 (``POSIX.1'').

HISTORY

     The compress command appeared in 4.3BSD.

BSD
								   May 17, 2002 							       BSD