Sponsored Content
Full Discussion: network interface -
Special Forums IP Networking network interface - Post 302647143 by Scott on Sunday 27th of May 2012 05:49:42 PM
Old 05-27-2012
These are the types of questions I would first search Google for an answer for. And I cannot believe you wouldn't find an answer there.

When you have an answer and struggle with the specifics of it, then that's different...
 

10 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

Network Interface

Hi ! Does anyone know how can i get information about my network interface ... if it works in half or full duplex mode !! Thx in adivance ! Witt (4 Replies)
Discussion started by: witt
4 Replies

2. AIX

Problem with a Network Interface

Hi every body, I have a Fiber Channel interface (fcs2) in AIX 5.2. This interface was fine & up but for some reason I could not return this interface UP again after I set it DOWN. When I tried to set this interface UP I encountered the following error: Method error... (7 Replies)
Discussion started by: aldowsary
7 Replies

3. Solaris

Network Interface Issue

Hi all, Here im facing problem with NIC Interface with my X86 Version of Solaris Express, even after loading module for that Interface. So please check this below mentioned log for your use and get back to me ASAP. - - - -- --... (0 Replies)
Discussion started by: baraghun
0 Replies

4. Solaris

Network interface not found ?

Hello, I have just installed Solaris 9 x86 in a VMWare and the 1st problem I have is to enable the networking. I can only see the loopback interface and nothing else. - I dont have any /etc/hostnames.xxx - ifconfig -a shows only the loopback - kstat -c net shows only the loopback ... Any... (11 Replies)
Discussion started by: Tex-Twil
11 Replies

5. Solaris

Network interface problem

Hi i have replace a NIC card on solaris 10 when i give the following command ifconfig -a it just show the lo0 (only loop back with inet 127.0.0.1) when i give the following command to config the interface, ifconfig elxl0 plumb ifconfig: plumb: elxl0: no such interface please help... (11 Replies)
Discussion started by: malikshahid85
11 Replies

6. Solaris

configure zones to have different network interface and network

i need to configure a zone to use different interface (bge2) than global and have connected to completely different network switch & to use its own defaultrouter and hosts file .. is it possible ..if so ..how ? Thanks (9 Replies)
Discussion started by: skamal4u
9 Replies

7. UNIX and Linux Applications

Access to network interface (Mac-network)

Hi, I'm a italian student. For my thesis I develop a gateway with protocol 6lowpan. For that I must access to network interface to develope my personal stack based on standard 802.15.4. Can you help me? I need an explanation for that. (0 Replies)
Discussion started by: berny88
0 Replies

8. IP Networking

Network interface-

Hello, Please what's the difference between: AND Thank you so much (3 Replies)
Discussion started by: chercheur857
3 Replies

9. Solaris

No network cable But Network interface is UP and Running

I've one Netra 240 After changing main board and system configuration card reader, Network is not accessible any more, Network interfaces are always UP and Running even when there is no cable connected to Network interfaces. I tried to restart and plumb/unplumb with no luck. ifconfig -a... (7 Replies)
Discussion started by: samer.odeh
7 Replies

10. UNIX for Dummies Questions & Answers

Adding a network interface to a bonded interface

I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)
Discussion started by: westmoreland
1 Replies
eXosip2 SUBSCRIBE and incoming subscriptions(3) 		    libeXosip2			   eXosip2 SUBSCRIBE and incoming subscriptions(3)

NAME
eXosip2 SUBSCRIBE and incoming subscriptions - Functions int eXosip_insubscription_build_answer (int tid, int status, osip_message_t **answer) int eXosip_insubscription_send_answer (int tid, int status, osip_message_t *answer) int eXosip_insubscription_build_request (int did, const char *method, osip_message_t **request) int eXosip_insubscription_build_notify (int did, int subscription_status, int subscription_reason, osip_message_t **request) int eXosip_insubscription_send_request (int did, osip_message_t *request) int eXosip_insubscription_remove (int did) Detailed Description Function Documentation int eXosip_insubscription_build_answer (inttid, intstatus, osip_message_t **answer) Build answer for an SUBSCRIBE request. Parameters: tid id of SUBSCRIBE transaction. status status for SIP answer to build. answer The SIP answer to build. int eXosip_insubscription_send_answer (inttid, intstatus, osip_message_t *answer) Send answer for an SUBSCRIBE request. Parameters: tid id of SUBSCRIBE transaction. status status for SIP answer to send. answer The SIP answer to send. (default will be sent if NULL) int eXosip_insubscription_build_request (intdid, const char *method, osip_message_t **request) Build a request within subscription. Parameters: did id of incoming subscription. method request method to build. request The SIP request to build. int eXosip_insubscription_build_notify (intdid, intsubscription_status, intsubscription_reason, osip_message_t **request) Build a NOTIFY request within subscription. Parameters: did id of incoming subscription. subscription_status subscription status (pending, active, terminated) subscription_reason subscription reason request The SIP request to build. int eXosip_insubscription_send_request (intdid, osip_message_t *request) Send a request within subscription. Parameters: did id of incoming subscription. request The SIP request to send. int eXosip_insubscription_remove (intdid) Remove incoming subscription context. Parameters: did identifier of the subscription. Author Generated automatically by Doxygen for libeXosip2 from the source code. Version 3.1.0 Sun Jun 24 2012 eXosip2 SUBSCRIBE and incoming subscriptions(3)
All times are GMT -4. The time now is 10:43 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy