Hi,
We recently purchased a 3 tb RAID. In the setup, it created 2 slices, one 2 tb and one 1 tb slice. Right now only the 2 tb slice is visible when booting up. I was told that the second slice needs to be mapped to a lun and a port like the first slice is.
Does anyone know how I would go... (1 Reply)
I have a list of LUN ID, my task is to find if disk has been added or not. How do I do that? I have been searching the forum and not able to find answer.
thanks (4 Replies)
Good day!
I’m a beginner HP-UX administrator. I have a task to create mulitipassing (I can mistake in this word) to new 3 disks which connected to my server from EVA. It is my first task to work with Secure Path. I have read what command I need to execute, but I don’t know, how to get the WWNN... (2 Replies)
Hello all,
I have the following env:
* DS4300 storage SAN
* AIX 5.3 Lpar (storage through vio server)
* AIX 5.3 Server
Some FS are too small do I'm setting up a process to increase the size of the FS.
To expand the size of the FS I plan to do the following for the physical AIX server,... (1 Reply)
Hello,
I want monting a LUN on a RX2660
I have created a LUN of 100Go with HP StorageWorks EVA and associated to my server.
For the moment I see it with the command below but after i can't used it
# ioscan -fnkC disk
Class I H/W Path Driver S/W State H/W Type Description ... (10 Replies)
Hi,
I have presented a LUN from my EVA 4400 to a RHEL server.
The server sees 4 paths to the LUN which I can see from fdisk.
If I want to add this LUN to my OS i.e.
# fdisk /dev/sd???
....which actual device do I run fdisk against?
I am running multipath so is there... (12 Replies)
Hi,
I am not getiting lun id information on VIO Server. I have used the command fget_config command.
just showing # prompt.
I would like know wheather any other command is there equiv of fget_config
which will display lun id? (4 Replies)
I have created a lun on Storage and connected it to server using fiber channel.
LUN is presented on new Server .
How do i check and mount this newly created LUN? (1 Reply)
Discussion started by: pinga123
1 Replies
10. Post Here to Contact Site Administrators and Moderators
UK(4) BSD Kernel Interfaces Manual UK(4)NAME
uk -- SCSI user-level driver
SYNOPSIS
uk* at scsibus? target ? lun ?
DESCRIPTION
The uk driver provides support for a process to address devices on the SCSI bus for which there is no configured driver.
A SCSI adapter must also be separately configured into the system before this driver makes sense.
KERNEL CONFIGURATION
If a count is given, that number of uk devices will be configured into the NetBSD kernel.
IOCTLS
The uk driver has no ioctls of its own but rather acts as a medium for the generic scsi(4) ioctls. These are described in <sys/scsiio.h>.
FILES
/dev/uk[0-255] unknown SCSI devices.
DIAGNOSTICS
All scsi(4) debug ioctls work on uk devices.
SEE ALSO ioctl(2), cd(4), ch(4), scsi(4), sd(4), ss(4), st(4)HISTORY
The uk driver appeared in 386BSD 0.1.
BSD October 11, 1993 BSD