I'm trying to configure IDS9.40 on Ret Hat 9.
The server has opened the port 1526/tcp
nmap (nmap -sT -O linux) reports correctly that the port is open.
However, portqry (portqry.exe -n 192.168.0.101 -e 1526 -p TCP) reports that the port is closed for connection:
TCP port 1526 (turbo... (0 Replies)
Hi all,
Got a strange one here, well not so much strange, different :-)
I need to work out if a server is particulary chatty, whether its talking / communicating heavily to a particular server, as Im planning to physically move the server to a different server, over a link. Hence the... (6 Replies)
Hi Everyone,
In my environment, I have few T5220. On the iLOM Management Card, I have both Network and Serial port are cabled, I don't have any issues while I try to connect using Network Management port, but when I try to connect the serial port for the same server which is actually connected... (3 Replies)
Not sure if this should be here or in the security section.
I am developing software that dynamically manipulates netfilter/iptables rules (through system() calls of the command strings, I'm not trying to hack the netfilter code). Basically, UDP messages that are sent by an application on, say,... (0 Replies)
Hello Team,
We are having weblogic which running on AIX 6.1 Lpar machine. We not enabled any firewall(IPSEC) in AIX level.
Our weblogic is running on cluster.Whenever we stop/restart the cluster we would like to stop/start the port(by using command) which used by the weblogic. Please... (2 Replies)
Hello,
Like many others, I have continued to get attempts to connect to my local net router from the Asia Pacific Network Information Centre and from RIPE Network Coordination Centre, Amsterdam. I would say that 90% of attempted connections come from these two locations. The originating IP... (5 Replies)
If I would like to know what connection , data , traffic in a network port ( eth0 ) , what can I do ?
ps. because I always found the network is very slow , so I would like what the network port is doing .
Thanks
Login ID ust3 is currently in read-only mode for multiple infractions. Creating... (0 Replies)
Hi Friends,
How to do port forwarding in AIX? We would like to re route traffic from port A to port B on AIX LPAR.
for example: my application is using 8080 port on LPAR and would like to use the 8081 instead of 8080. By default application was configured with 8080. But instead of changing... (2 Replies)
My son does homework on a school laptop. I was thinking about setting up a gateway on my home network, so that I can monitor web traffic and know if he is doing his homework without standing over his shoulder. Ideally I would like to use the Raspberry Pi Model b that I already have. However, I... (15 Replies)
Below is what i did to open the firewall port on
# sudo firewall-cmd --zone=public --add-port=27012/tcp --permanent
Warning: ALREADY_ENABLED: 27012:tcp
success
# sudo firewall-cmd --reload
success
# firewall-cmd --list-all
public
target: default
icmp-block-inversion: no
... (10 Replies)