I'm fairly new to hpux, so this is what i've been trying to figure out. Is it possible to get any logs on hpux that would indicate if the system, cpu, or other hardware components reached above normal or critical temperatures?
Thanks,
-K (0 Replies)
Is there command in sco unixware 7.1.3 from which i can find the temperature of the system/hardware.
Something equivalent to prtdiag in solaris maybe
thanks (1 Reply)
Hi all
I have a SUN V480 server with 4 processores and I've noticed that the temperature for 2 of the 4 processers are quite high (63 degrees Celsius).
Does anyone know what the operating temperatures of the Sparc CPU's are? I'm not getting any warning messages yet, but I want to resolve the... (3 Replies)
Hi,
I just set up a raid Z array in solaris xpress and I notice that the drives feel pretty damn hot. I use speedfan to monitor the temperatures of the hard drives in XP. Is there a similar program for solrais? I assume there would be since the drives all have temp sensors in them, but I... (2 Replies)
How to get a CPU temperature and current power consumption in T5220 server both from system controller and Operating system. I need details by cores. Thanks in advance. (13 Replies)
People hello to everybody exist a way to do a script for view the temperature. I have
Red Hat Linux release 9 (Shrike)
Kernel 2.4.20-8 on an i686
THANk YOU FOR YOUR TIME. (4 Replies)
Hello all,
I am using prtdiag -v command to find the temperature sensors . And i dont see the following o/p .
ystem Configuration: Hewlett-Packard HP Z400 Workstation
BIOS Configuration: Hewlett-Packard 786G3 v01.17 08/19/2009
==== Processor Sockets ====================================
... (2 Replies)
Hello,
I am trying to work on a temperature script to check temperatures on my systems. Im trying to get the basics laid out first. So far i have a command:
/usr/sbin/prtpicl -v -c temperature-sensor # (must run as root)
This command kicks back alot of information but i only want the... (3 Replies)
What is the max operating temperature for 'UltraSPARC IIIi 1 GHz' ?
thanks. (1 Reply)
Discussion started by: orange47
1 Replies
LEARN ABOUT DEBIAN
amdtemp
AMDTEMP(4) BSD Kernel Interfaces Manual AMDTEMP(4)NAME
amdtemp -- device driver for AMD K8, K10 and K11 on-die digital thermal sensor
SYNOPSIS
To compile this driver into the kernel, place the following line in your kernel configuration file:
device amdtemp
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
amdtemp_load="YES"
DESCRIPTION
The amdtemp driver provides support for the on-die digital thermal sensor present in AMD K8, K10 and K11 processors.
For the K8 family, the amdtemp driver reports each cores' temperature through a sysctl node in the corresponding CPU devices's sysctl tree,
named dev.amdtemp.%d.sensor{0,1}.core{0,1}. The driver also creates dev.cpu.%d.temperature displaying the maximum temperature of the two
sensors located in each CPU core.
For the K10 and K11 families, the driver creates dev.cpu.%d.temperature with the temperature of each core.
BUGS
AMD K9 is not supported because temperature reporting has been replaced by Maltese.
SEE ALSO sysctl(8)HISTORY
The amdtemp driver first appeared in FreeBSD 7.1.
AUTHORS
Rui Paulo <rpaulo@FreeBSD.org>
Norikatsu Shigemura <nork@FreeBSD.org>
BSD April 8, 2008 BSD