Sponsored Content
Top Forums UNIX for Advanced & Expert Users Surfing the Internet problems with multiple browsers Post 302535913 by Corona688 on Saturday 2nd of July 2011 06:03:09 PM
Old 07-02-2011
Also check if you have a bad http_proxy exported anywhere.
 

8 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

Surfing the web with Lynx

Linux detected my modem(finally!) and I then proceeded it to configure it with Minicom according to the instructions here. I got it configured, and can dial up to my ISP, but now I am trying to figure out how to get Lynx to use the connection. Any ideas? (3 Replies)
Discussion started by: Furtoes00
3 Replies

2. Cybersecurity

annonymous surfing

hello everyone! i am interested in SurfSolo, from Encryption Software, Anonymous Web Surfing, Computer Firewall it is a like VPN but for personal use, has any of you tried it yet and if yes do you have any suggestions and opinions about it? thanks (0 Replies)
Discussion started by: sheherezad
0 Replies

3. UNIX for Dummies Questions & Answers

Having wireless Internet problems

I feel like the true definition of a newb but I guess you gotta start somewhere. I installed Gentoo on my laptop yesterday, it's a gnome based environment and I cannot get any wireless internet. The iwconfig and net-setup commands are not being recognized. I'm not sure what the problem is, I've... (1 Reply)
Discussion started by: jessparkscars
1 Replies

4. UNIX for Dummies Questions & Answers

Problems connecting to the Internet

I am trying to connect a Solaris 10 PC to the internet via a Linksys router and a cable modem. I have tried following suggestions in one of the posts here for manual setup but so far no luck. Does the Solaris 10 install for x86 automatically pick up the internet connection? Dave :>) (4 Replies)
Discussion started by: dohling
4 Replies

5. Red Hat

problems with internet connectivity

I had a strange problem.Recently, I virtualized my RHEL 5 system by installing Fedora 8 as guest operating system. The installation went fine. But, after installation my internet connection stopped working. Any suggestions?. I was on TataIndicom wireless USB modem. I haven't had any problems with... (3 Replies)
Discussion started by: jaghelp323
3 Replies

6. IP Networking

Problems with Internet setup

Hi, I am using VMWARE and when I have the network connection set to NAT and the VM set to DHCP I get internet connection. But when I set the connection to BRIDGED and assign a static IP address I loose internet connection. I have used netconfig to manually assign the IP Address, GATEWAY, and... (5 Replies)
Discussion started by: mojoman
5 Replies

7. Web Development

apache, surfing a directory

Hi, I have a directory and I need a url that users can surf it.like ftp. my web server is apache. Thanks in advance. (2 Replies)
Discussion started by: Zaxon
2 Replies

8. SCO

problems with ftp without internet

Dear Friends, I have the following problem, when there is no internet does not work the ftp to the server, with the local network use a router for dhcp SCO OpenServer 6.0 terminals with windows 7 ftp client ftplite and also use ftp from ms-dos to do? regards (1 Reply)
Discussion started by: Edgar Guevara
1 Replies
socal(7D)							      Devices								 socal(7D)

NAME
socal - Serial Optical Controller for Fibre Channel Arbitrated Loop (SOC+) device driver SYNOPSIS
socal@sbus-slot,0 DESCRIPTION
The Fibre Channel Host Bus Adapter is an SBus card which implements two full duplex Fibre Channel interfaces. Each Fibre Channel interface can connect to a Fibre Channel Arbitrated Loop (FC-AL). The socal device driver is a nexus driver and implements portions of the FC-2 and FC-4 layers of FC-AL. FILES
/kernel/drv/socal ELF Kernel Module ATTRIBUTES
See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Architecture |SPARC | +-----------------------------+-----------------------------+ SEE ALSO
sbus(4), sf(7D), ssd(7D) Writing Device Drivers ANSI X3.230-1994, Fibre Channel Physical and Signalling Interface (FC-PH) ANSI X3.272-1996, Fibre Channel Arbitrated Loop (FC-AL) Fibre Channel Private Loop SCSI Direct Attach (FC-PLDA) DIAGNOSTICS
The messages described below may appear on system console in addition to being logged. On the console, these messages are preceded by: socal%d: port %a where %d is the instance number of the socal controller and %a is the port on the host adapter. Fibre Channel Loop is ONLINE The Fibre Channel loop is now online. Fibre Channel Loop is OFFLINE The Fibre Channel loop is now offline. attach failed: device in slave-only slot. Move soc+ card to another slot. attach failed: bad soft state. Driver did not attach, devices will be inaccessible. attach failed: unable to alloc xport struct. Driver did not attach, devices will be inaccessible. attach failed: unable to map eeprom Driver was unable to map device memory; check for bad hardware. Driver did not attach to device, devices will be inaccessible. attach failed: unable to map XRAM Driver was unable to map device memory; check for bad hardware. Driver did not attach to device, devices will be inaccessible. attach failed: unable to map registers Driver was unable to map device registers; check for bad hardware. Driver did not attach to device, devices will be inaccessible. attach failed: unable to access status register Driver was unable to map device registers; check for bad hardware. Driver did not attach to device, devices will be inaccessible. attach failed: unable to install interrupt handler Driver was not able to add the interrupt routine to the kernel. Driver did not attach to device, devices will be inaccessible. attach failed: unable to access host adapter XRAM Driver was unable to access device RAM; check for bad hardware. Driver did not attach to device, devices will be inaccessible. attach failed: unable to write host adapter XRAM Driver was unable to write device RAM; check for bad hardware. Driver did not attach to device, devices will be inaccessible. attach failed: read/write mismatch in XRAM Driver was unable to verify device RAM; check for bad hardware. Driver did not attach to device, devices will be inaccessible. SunOS 5.11 9 May 1997 socal(7D)
All times are GMT -4. The time now is 01:10 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy