1. High Performance Computing

I have rcently setup a 4 node cluster running sun cluster 3.2 and I have installed 4 zones on each node. when installing the zones I had to install the zone on all nodes the on the last node do a zlogin -C <zonename> this worked ok. theni I tried to siwitch the zone to node a thei work... (14 Replies)

2. Solaris

Hi, I am running Solaris 10 + VCS 5 in one of our environment. Recently one of my colleague configured all resources in a single service group.( ie, one service group which has all resources) ,Usually we create seperate service groups for Hardware & for application. For eg: SYS_HW_GRP, will... (0 Replies)

3. AIX

Hi, I have a requirement to monitor the HACMP Resource Groups. At present in my environment, if the Resource Groups fail over from preferred node to Secondary node we dont get notification. Can some one help me in creating a scrript. I have more than one RG online. (Max 4 Resource Groups in... (2 Replies)

4. AIX

Hi, I have a 2 node Cluster. Which is working in active/passive mode (i.e Node#1 is running and when it goes down the Node#2 takes over) Now there's this requirement that we need a mount point say /test that should be available in active node #1 and when node #1 goes down and node#2 takes... (6 Replies)

5. AIX

Hi, I'm new to HACMP. Currently I setup a cluster with nfs cross-mount follow this guide: kristijan.org NFS cross-mounts in PowerHA/HACMPMy cluster has two nodes: erp01 and erp02. I'm using nfs4 with filesystem for nfs is: /sapnfs Cluster start without problems. But I cannnot move RG (with... (3 Replies)

6. AIX

Hello. I am Running AIX 6.1 and PowerHA 6.1 I have an active/active cluster (Prod/Dev) cluster. Each side will failover to the other. I have on my prod side an active volume group with a file system. The VG is imported on both nodes and active (varried on, file system mounted) on the prod... (3 Replies)

7. AIX

Hi all, I have the following in hacmp.out for bringing Resource group online. Volume groups themselves are Enhanced-Capable and on each node I can varyon and mount filesystems. +main1_rg_01:cl_activate_vgs STATUS=0 +main1_rg_01:cl_activate_vgs typeset -li STATUS +main1_rg_01:cl_activate_vgs... (2 Replies)

8. AIX

Hello all, I'm working to fix a two-node SysMirror cluster that uses NFS mounts from a NetApp appliance as the data repository. Currently all the NFS mounts/unmounts are called from the application controller scripts, and since file collection isn't currently working, (One fight at at time... (3 Replies)