I asked a similar question earlier and got a very good answer but a new doubt came up. This is a few lines of a '/sbin/ifconfig' command on my PC:
RX packets:3781025 errors:0 dropped:0 overruns:0 frame:0
TX packets:1941909 errors:0 dropped:0 overruns:0 carrier:0
Does the RX and TX packets... (1 Reply)
SunOS Release 5.7.
Original ifconfig -a output:
pnt0: flags=863<UP, BROADCAST,NOTRAILERS........
inet 10.2.34.49 netmask fffffe00 broadcast 10.2.34.255 ...
Attempted to change ip address for pnt0. Typed the following command and forgot the "netmask"
"ifconfig pnt0 10.2.35.49... (1 Reply)
This will most likely be a real dumb question for a HP-UX admin, but here it goes anyhow.
lan0 - is up and configured
lan1 - is down, I want to bring it up.
lanconfig....ifconfig is there a difference?
My real question is, in solaris there is an /etc/hostname."?" file, is there a... (4 Replies)
I am trying to change an IP address on a machine running HPUX10
After I change it I can ping it from the outside but it completely locks the console. After a reboot it returns back to its previous IP. Any ideas??
Thanks
Brian (7 Replies)
if i have the command ifconfig eth0, what will the output be and how can i use either awk or grep to isolate and display the IP address, subnet mask and physical address of my host (1 Reply)
On prior versions to solaris 10 when I want to add/change the IP address of an interface I will use this command.
ifconfig eri0 down
ifconfig eri0 192.xxx.xxx.xxx netmask 255.xxx.xxx.xxx up
then change /etc/hosts so that /etc/hostname.eri0 picks up on the correct IP.
I strange thing... (2 Replies)
why the ifconfig command is not working in my machine?
it says "-bash: ifconfig: command not found"
why its says that?
actually i m looking for "how can I know the Network Interface Card physical address?"
Requesting u all for help.
thanks (3 Replies)
I have a script problem that I am not able to solve due my very limited understanding of unix/awk.
This is the contents of test.sh
awk '{print $1}'
From the prompt if I enter:
./test.sh Hello World
I would expect to see "Hello" but all I get is a blank line. Only then if I enter "Hello... (2 Replies)
Hi Experts,
I am trying to get system output to capture inside awk , but not working:
Please advise if this is possible :
I am trying something like this but not working, the output is coming wrong:
echo "" | awk '{d=system ("date") ; print "Current date is:" , d }'
Thanks, (5 Replies)