Sponsored Content
Full Discussion: HACMP subnetmasks
Operating Systems AIX HACMP subnetmasks Post 302377385 by raba on Friday 4th of December 2009 12:52:24 AM
Old 12-04-2009
@dukesdd
Hi,

@dukesdd
- because I have a question
- see redbooks below and many more HACMP related books
- version 5.1 and up
- usually restrictions keep you from laughing

it's in redbook
"Certification Study Guide - pSeries HACMP for AIX" sg246187.pdf page 164:
"Verify that all boot, service and standby addressers have the same
subnetmask and that standby addresses will not be on the same subnet as
the boot and service addressers."

and "PowerHA Cookbook" sg247739.pdf page 173:
"Subnet requirements will vary depending upon the configuration chosen
(IP Address Takeover -IPAT- via replacement or alias). However, all the
communication interfaces configured in the same PowerHA Network Name must
have the same subnet mask, while interfaces belonging to different PowerHA
Network Names can have either the same or a different network mask."

Last edited by raba; 12-04-2009 at 02:06 AM.. Reason: @@
 

10 More Discussions You Might Find Interesting

1. AIX

Hacmp

(0 Replies)
Discussion started by: mhenryj
0 Replies

2. AIX

HACMP (Again)

Hello I am a noobie to HACMP I have 2 55A servers and a 7031 disk subsystem For HACMP to work, do I need to have the hdisks on both servers to match the same drives?? The hdisks on each box are currently different: hdisk0 and hdisk1 are the internal disks and hdisk2-5 are on the D24 on... (1 Reply)
Discussion started by: mhenryj
1 Replies

3. HP-UX

HACMP in HP-UX

Hi, Can anybody advice whether it is possible to configure HACMP in HP-UX Server. To my knowledge HACMP is IBM Solution. Thanks && Regards, N. Poorna Chandra Rao. (2 Replies)
Discussion started by: npcrao
2 Replies

4. AIX

HACMP

Hi, Can we use network for heartbeat, I mean can we use different network card for heartbeat. (6 Replies)
Discussion started by: vjm
6 Replies

5. AIX

HACMP

hi can anyone explain the concepts of HACMP and configuration (step by step) (2 Replies)
Discussion started by: udtyuvaraj
2 Replies

6. AIX

HACMP does not start db2 after failover (db2nodes not getting modified by hacmp)

hi, when I do a failover, hacmp always starts db2 but recently it fails to start db2..noticed the issue is db2nodes.cfg is not modified by hacmp and is still showing primary node..manually changed the node name to secondary after which db2 started immediately..unable to figure out why hacmp is... (4 Replies)
Discussion started by: gkr747
4 Replies

7. AIX

HACMP

Does anyone has idea about, what is the ibm standard HACMP trip interval? We have 20 second. lssrc -ls topsvcs Subsystem Group PID Status topsvcs topsvcs 1843200 active Network Name Indx Defd Mbrs St Adapter ID Group ID HB Interval =... (7 Replies)
Discussion started by: allwin
7 Replies

8. AIX

Help with HACMP

Hi. We have a two node HA cluster. We got a request to change one of the VG name? Is there an option to do this online ? If it requires downtime can someone please explain me the steps for doing it ? Let me know if you need any outputs from the servers (1 Reply)
Discussion started by: newtoaixos
1 Replies

9. AIX

Hacmp

Hi, I have question about HA. I have 2 node cluster (node A and node B). I have configured network and disk HB. If my network is up and i remove both the fc cables from node A will my cluster failover to node B? I have checked and its not working, if i want my cluster to failover in this... (5 Replies)
Discussion started by: powerAIX
5 Replies

10. AIX

Hacmp

hello ive 2 nodes aix 6100-04-10-1119 with hacmp 6.1.0.0 my qustion is : can i add default gateway to one member node with hacmp a live or to do take over to realse one of the members ? thanks When it is urgent, then open the thread up in the appropriate subforum next time, thanks. (3 Replies)
Discussion started by: ariec
3 Replies
netmasks(4)                                                        File Formats                                                        netmasks(4)

NAME
netmasks - network mask database SYNOPSIS
/etc/inet/netmasks /etc/netmasks DESCRIPTION
The netmasks file contains network masks used to implement IP subnetting. It supports both standard subnetting as specified in RFC-950 and variable length subnetting as specified in RFC-1519. When using standard subnetting there should be a single line for each network that is subnetted in this file with the network number, any number of SPACE or TAB characters, and the network mask to use on that network. Network numbers and masks may be specified in the conventional IP `.' (dot) notation (like IP host addresses, but with zeroes for the host part). For example, 128.32.0.0 255.255.255.0 can be used to specify that the Class B network 128.32.0.0 should have eight bits of subnet field and eight bits of host field, in addition to the standard sixteen bits in the network field. When using variable length subnetting, the format is identical. However, there should be a line for each subnet with the first field being the subnet and the second field being the netmask that applies to that subnet. The users of the database, such as ifconfig(1M), perform a lookup to find the longest possible matching mask. It is possible to combine the RFC-950 and RFC-1519 form of subnet masks in the net- masks file. For example, 128.32.0.0 255.255.255.0 128.32.27.0 255.255.255.240 128.32.27.16 255.255.255.240 128.32.27.32 255.255.255.240 128.32.27.48 255.255.255.240 128.32.27.64 255.255.255.240 128.32.27.80 255.255.255.240 128.32.27.96 255.255.255.240 128.32.27.112 255.255.255.240 128.32.27.128 255.255.255.240 128.32.27.144 255.255.255.240 128.32.27.160 255.255.255.240 128.32.27.176 255.255.255.240 128.32.27.192 255.255.255.240 128.32.27.208 255.255.255.240 128.32.27.224 255.255.255.240 128.32.27.240 255.255.255.240 128.32.64.0 255.255.255.192 can be used to specify different netmasks in different parts of the 128.32.0.0 Class B network number. Addresses 128.32.27.0 through 128.32.27.255 have a subnet mask with 28 bits in the combined network and subnet fields (often referred to as the subnet field) and 4 bits in the host field. Furthermore, addresses 128.32.64.0 through 128.32.64.63 have a 26 bits in the subnet field. Finally, all other addresses in the range 128.32.0.0 through 128.32.255.255 have a 24 bit subnet field. Invalid entries are ignored. SEE ALSO
ifconfig(1M), inet(7P) Postel, Jon, and Mogul, Jeff, Internet Standard Subnetting Procedure, RFC 950, Network Information Center, SRI International, Menlo Park, Calif., August 1985. V. Fuller, T. Li, J. Yu, K. Varadhan, Classless Inter-Domain Routing (CIDR): an Address Assignment and Aggregation Strategy, RFC 1519, Network Information Center, SRI International, Menlo Park, Calif., September 1993. T. Pummill, B. Manning, Variable Length Subnet Table For IPv4, RFC 1878, Network Information Center, SRI International, Menlo Park, Calif., December 1995. NOTES
/etc/inet/netmasks is the official SVr4 name of the netmasks file. The symbolic link /etc/netmasks exists for BSD compatibility. SunOS 5.10 7 Jan 1997 netmasks(4)
All times are GMT -4. The time now is 06:45 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy