RSH(1)							    BSD General Commands Manual 						    RSH(1)

NAME

     rsh -- remote shell

SYNOPSIS

     rsh [-46dn] [-l username] [-t timeout] host [command]

DESCRIPTION

     The rsh utility executes command on host.

     The rsh utility copies its standard input to the remote command, the standard output of the remote command to its standard output, and the
     standard error of the remote command to its standard error.  Interrupt, quit and terminate signals are propagated to the remote command; rsh
     normally terminates when the remote command does.	The options are as follows:

     -4    Use IPv4 addresses only.

     -6    Use IPv6 addresses only.

     -d    Turn on socket debugging (using setsockopt(2)) on the TCP sockets used for communication with the remote host.

     -l username
	   Allow the remote username to be specified.  By default, the remote username is the same as the local username.  Authorization is deter-
	   mined as in rlogin(1).

     -n    Redirect input from the special device /dev/null (see the BUGS section of this manual page).

     -t timeout
	   Allow a timeout to be specified (in seconds).  If no data is sent or received in this time, rsh will exit.

     If no command is specified, you will be logged in on the remote host using rlogin(1).

     Shell metacharacters which are not quoted are interpreted on local machine, while quoted metacharacters are interpreted on the remote
     machine.  For example, the command

	   rsh otherhost cat remotefile >> localfile

     appends the remote file remotefile to the local file localfile, while

	   rsh otherhost cat remotefile ">>" other_remotefile

     appends remotefile to other_remotefile.

FILES

     /etc/hosts
     /etc/auth.conf

SEE ALSO

     rlogin(1), setsockopt(2), rcmd(3), ruserok(3), auth.conf(5), hosts(5), hosts.equiv(5), rlogind(8), rshd(8)

HISTORY

     The rsh command appeared in 4.2BSD.

BUGS

     If you are using csh(1) and put a rsh in the background without redirecting its input away from the terminal, it will block even if no reads
     are posted by the remote command.	If no input is desired you should redirect the input of rsh to /dev/null using the -n option.

     You cannot run an interactive command (like ee(1) or vi(1)) using rsh; use rlogin(1) instead.

     Stop signals stop the local rsh process only; this is arguably wrong, but currently hard to fix for reasons too complicated to explain here.

BSD
								 October 16, 2002							       BSD