03-21-2009
10 More Discussions You Might Find Interesting
1. AIX
Hey Alll
Thanks for the help u give me yesterday,i need a help again from u all guys i have RS 6000 server with AIX 4.3.3 OS and with external storage (multipack) with 12 Hard disk drive which will be connected to RS 6000 scsi controller ,i dont have any raid card. now i have to... (0 Replies)
Discussion started by: solaris8in
0 Replies
2. SCO
recently we have purchased hp proliant ml350 g5 server and configured raid 5 with hp smartarray p200i sas controller.but i could not found any sas raid controller hp smartarry p200i driver for sco unix 5.0.7 :(.i searched on hp support site,but no use.any one can help. (3 Replies)
Discussion started by: prakrithi
3 Replies
3. Solaris
I need to install a raid HBA internal card on a T5240. The reason is I have
more drives and the current mother board controller does not support more
than 4 drives.
My question is I have raidctl set up on current drives. If I install new HBA
card do I have to delete current raidctl and... (3 Replies)
Discussion started by: photon
3 Replies
4. Solaris
Hi all
i would like to ask some suggests about my next job!
I have to install a new Sun Netra T5220, with an additional internal StorageTek SAS HBA Raid.
The problem come in if every disk is now controlled by the HBA, how can I install the OS?
No disk is being detected by the OS.
SAS card... (2 Replies)
Discussion started by: kakabobo
2 Replies
5. Solaris
i was given a task which needs to perform a raid 1 on the boot disk, and 4 other disks on raid 10.
Is there any other alternative in installing solaris 10 other than through network installation?will be using solaris update 6.
while reading through the user guide i got pretty confuse.
... (1 Reply)
Discussion started by: monstar1407
1 Replies
6. Red Hat
We have configured software based RAID5 with LVM on our RHEL5 servers. Please let us know if its good to configure software RAID on live environment servers. What can be the disadvantages of software RAID against hardware RAID (4 Replies)
Discussion started by: mitchnelson
4 Replies
7. AIX
Hello folks,
Could someone tell me why I unable to create pdisks for a RAID Array
# lscfg | grep scsi
+ sisscsia0 U787A.001.DPM0707-P1 PCI-X Dual Channel Ultra320 SCSI Adapter
+ scsi0 U787A.001.DPM0707-P1-T10 PCI-X Dual Channel Ultra320 SCSI Adapter... (12 Replies)
Discussion started by: filosophizer
12 Replies
8. Solaris
Hi !
I've been given a T5240 with 4 disks and 2 HBA cards (but no array connected). I did a factory reset on SP and NVRAM clean on OBP because the server had been used before.
I boot cdrom in single mode and try to create a hw mirror with disks from c1... but only c2 is seen by raidctl.
... (2 Replies)
Discussion started by: delavega
2 Replies
9. Red Hat
Hello,
I want to delete a RAID configuration an old server has.
Since i haven't the chance to work with the specific raid controller in the past can you please help me how to perform the configuraiton?
I downloaded IBM ServeRAID Support CD but i wasn't able to configure the video card so i... (0 Replies)
Discussion started by: @dagio
0 Replies
10. AIX
OSLevel: 5300-10-02-0943
System Model: IBM,8203-E4A
Power 6
==
Hi!
I replaced a failed pdisk in the raid enclosure as follows,
- rmdev -l 'pdisk18' '-d'
- Replaced it.
- cfgmgr (detected)
- I can see the new drive, with the correct serial #
lscfg -v -l pdisk18
pdisk18... (2 Replies)
Discussion started by: estrar
2 Replies
LEARN ABOUT OPENSOLARIS
root_archive
root_archive(1M) System Administration Commands root_archive(1M)
NAME
root_archive - manage bootable miniroot archives
SYNOPSIS
/boot/solaris/bin/root_archive pack archive root
/boot/solaris/bin/root_archive unpack archive root
/boot/solaris/bin/root_archive packmedia solaris_image root
/boot/solaris/bin/root_archive unpackmedia solaris_image root
DESCRIPTION
The root_archive utility is used to manage bootable miniroot archives and is currently only available on x86 platforms. The utility can
pack and unpack boot/root archives in both ufs and hsfs (iso9660) format. It will always generate ufs archives.
root_archive also uses the lofi file driver to export a file as a block device (see lofi(7D)) and mount to mount or unmount file systems
and remote resources (see mount(1M)). root_archive requires the same privileges that are needed to run these commands.
SUBCOMMANDS
The root_archive command has the following subcommands:
pack archive root Pack from the image found under the root directory to the archive.
unpack archive root
Unpack from the archive to an unpacked image under the root directory.
packmedia solaris_image root
Pack the solaris image to the root directory.
unpackmedia solaris_image root
Unpack the solaris image from the root directory.
For packmedia and unpackmedia, other items that do not go into the ramdisk image are copied or uncopied (see cpio(1)) as well. Specifi-
cally, this includes all the packaging databases needed for pkgadd and the other packaging utilities to succeed which are not used in the
running and hence pruned to conserve memory.
EXAMPLES
Example 1 Unpacking the Solaris x86 install image
The following command unpacks the current Solaris image from the root directory:
# root_archive unpackmedia
/export/nv/solarisdvd.nvx_dvd/latest /export/Boot
Where /export/nv/solarisdvd.nvx_dvd/latest represents a path to a Solaris x86 install image and /export/Boot is a directory that will be
purged or created, as necessary.
Example 2 Packing the Solaris x86 install image
The following command packs the current Solaris image to the root directory:
# root_archive packmedia
/export/nv/solarisdvd.nvx_dvd/latest /export/Boot
EXIT STATUS
The following exit values are returned:
0 The command completed successfully.
1 The command exited due to an error.
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
+-----------------------------+-----------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+-----------------------------+-----------------------------+
|Availability |SUNWcsu |
+-----------------------------+-----------------------------+
|Interface Stability |Stable |
+-----------------------------+-----------------------------+
SEE ALSO
cpio(1), bootadm(1M), mount(1M), attributes(5), lofi(7D)
SunOS 5.11 26 Sep 2005 root_archive(1M)