Sponsored Content
Operating Systems Solaris Disable Inbuilt multipathing software of Solaris 10 Post 302269751 by reborg on Thursday 18th of December 2008 01:19:05 PM
Old 12-18-2008
It should be off by changing mpxio-disable to yes for iSCSI. It's set in /kernel/drv/iscsi.conf
 

10 More Discussions You Might Find Interesting

1. IP Networking

Quick Poll: Solaris IP Multipathing

I've setup Solaris IP Multipathing under Solaris whenever the hardware to do so was available. I find it amazing though that so few places I've worked at don't use it until I arrive. I wanted to find out if I'm running into all the exceptions, or is it really not being used? ... (3 Replies)
Discussion started by: kduffin
3 Replies

2. Solaris

disable telnet on Solaris

All - would you please some one help me to disable telnet on Solaris? /etc/inetd.conf Thanks :confused: (11 Replies)
Discussion started by: March_2007
11 Replies

3. Solaris

solaris multipathing

I have solaris 10 sparc. I installed a Qlogic hba card. This card is connected on a brocade switch and the brocade is connected on 2 different controllers on a Hitachi disk bay. I formated 2 luns. On my solaris system, i have 4 disk. How to configure solaris 10 to fix the dual disk view. ... (4 Replies)
Discussion started by: simquest
4 Replies

4. Solaris

Solaris IP Multipathing (IPMP) Help

Hello All, I work for a Health care company at a local trauma hospital. I maintain a Picture Archiving and Communication System (PAC's). Basically, any medical images (X-Ray, CT, MRI, Mammo, etc) are stored digitally on the servers for viewing and dictation from diagnostic stations. I took over... (10 Replies)
Discussion started by: mainegeek
10 Replies

5. Solaris

Solaris IP Multipathing

Hi, I saw your post on the forums about how to setup IP multipathing. I wanted your help on the below situation . I have 2 servers A and B . Now they should be connected to 2 network switches . S1 and S2. Now is it possible to have IP Multipathing on each of the servers as follows ? ... (0 Replies)
Discussion started by: maadhuu
0 Replies

6. Solaris

Solaris multipathing

Hai we using emc storage which is conneted to M5000 through san switch. we asign 13 luns but in server it is showing 22 luns. i enable the solaris multipathing (MPxIO) #more /kernel/drv/fp.conf in that file MPxio-disable=no #mpathadm list lu it shows ... (2 Replies)
Discussion started by: joshmani
2 Replies

7. Solaris

Disable all the logs in Solaris

Hi Is there anyway to disable all logs/logging (lastlog, sulog, messages etc.) in Solaris 9&10? I know this is not recommended but i just want to know if this is possible. TIA Reddy (8 Replies)
Discussion started by: reddyr
8 Replies

8. Solaris

Solaris 11 disable IPv6

I've new installed Solaris 11 on Sparc T4-1. I'd like to disable IPv6 but with no luck. lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1 inet 127.0.0.1 netmask ff000000 net0: flags=1000803<UP,BROADCAST,MULTICAST,IPv4> mtu 1500 index 2 inet... (6 Replies)
Discussion started by: samer.odeh
6 Replies

9. Solaris

ZeusIOPS multipathing failed Solaris 11

hi, just installed solaris 11.1 (11.1.9.5.1) on a sun7410 ZFSSA (x4440 + j4400), but when I enable multipathing with "stmsboot -e", only the 1TB SATA drives inside the j4400 are configured as multipathed vhci / mpxio devices, but the logzillas / ZeusIOPS drives are skipped. the server is... (0 Replies)
Discussion started by: pressy
0 Replies

10. Solaris

Can't disable CPU in Solaris

hello all i have an issue about a solaris V440 cpu, im logged in the Ok prompt i can't disable a CPU3, i can't see it in dev list, i see only the cpu3-bank0 to cpu-bank4 please help me to disable it thank youuu (3 Replies)
Discussion started by: walidadam
3 Replies
iscsi(7D)							      Devices								 iscsi(7D)

NAME
iscsi - iSCSI software initiator driver DESCRIPTION
The iscsi driver is a software initiator that transports SCSI commands over TCP/IP as described in RFC 3720. The initiator is administered through iscsiadm(1M). The iscsi initiator acts as a host adapter driver that attaches the appropriate target driver (for example sd(7D) for disks or st(7D) for tapes) for devices it discovers. See the System Administration Guide for more information. FILES
/kernel/drv/iscsi 32-bit ELF kernel driver. /kernel/drv/sparcv9/iscsi 64-bit SPARC ELF kernel driver. /kernel/drv/amd64/iscsi 64-bit AMD64 ELF kernel driver. /kernel/drv/iscsi.conf Driver configuration file. /etc/iscsi/* iscsi persistent store. ATTRIBUTES
See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Availability |SUNWiscsir, SUNWiscsiu | +-----------------------------+-----------------------------+ SEE ALSO
iscsiadm(1M), attributes(5) RFC 3720 Internet Small Computer Systems Interface (iSCSI) System Administration Guide: Devices and File Systems, Chapter 15 SunOS 5.11 12 April 2005 iscsi(7D)
All times are GMT -4. The time now is 02:56 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy