1. UNIX for Dummies Questions & Answers

Our shops server runs SCO Openserver 5 release 5. It has two network cards in it (one on 10.0.0.6 and one on 90.0.0.99). When I run scoadmin and look at the network settings it show both my 3com network cards and a loop back driver http://theentertainer.com/james/untitled.jpg Can anyone tell... (1 Reply)

2. Solaris

Hi, I'm looking for a command to be able to disable a network card under the boot PROM. I need it to force my Jumpstart to use the Ethernet card of my server (V880) instead of my fiber card (gem0). Thanks, Fabien (6 Replies)

3. Solaris

Hi, I'm looking for a command to be able to list all my network cards available on my server. With the command "ifconfig - a", I can only see to configured network card(s) Any idea ? :confused: Thanks a lot for your help, Fabien (5 Replies)

4. AIX

The title speaks for itself. I have never attempted this but understand there is a way to use two network cards (en0 and en1) with the same IP address so as to load balance the traffic flow through both cards. Anyone know the answer? (4 Replies)

5. Solaris

Hi again, Does somebody have somewhere a spreadsheet to know the link with network interface and card models ? Ce = Copper ? Bge = Fiber Gigaswift ? etc ... (1 Reply)

6. Solaris

Hi all, I have a server running with Solaris and I have 2 Pci cards installed on this server (since a while), 1 with 4 coppers connections output and one with a Fiber network connection output. Today, this server is using the on board network connection (Ce0). How can I find the other... (7 Replies)

7. Solaris

Hi all I hate networking, I hate everything to do with it. Its something I do in anger in one contract, then forget. This is more of a question / than a problem. So, on a solaris 10 server, using older qfe cards, Ive got a sun truck with 4 nics (qfe0,3,4,7), and a ipmp pair (hemo0,qfe1).... (2 Replies)

8. Hardware

Hello everybody, I'm having troubles with Slackware 13.1 and network cards. I have one on-board Ethernet card (which is recognized and works okay) and a PCI Ethernet card (which is also recognized, but doesn't appear in 'ifconfig -a'). If i run a 'lspci', i can see the kernel recognized the... (5 Replies)

9. AIX

Hi How to check if my AIX server has any network related errors ? (2 Replies)

10. UNIX for Dummies Questions & Answers

Hi All, I have just setup a webserver running on a linux box. This server has 2 ethernet cards and only 1 is in used now. eg. 192.168.10.1 is my server IP. All users from 192.168.10.X can access my webserver. However, users from another LAN 10.10.10.X are not able to access my webserver. They... (0 Replies)