Sponsored Content
Operating Systems Solaris Removable External SCSI Harddrive Post 302217132 by tlee on Tuesday 22nd of July 2008 03:03:34 AM
Old 07-22-2008
"If you keep on seeing that the disk drive is not available, most probably the disk has gone bad (possible). meaning you wont be able to access any data on that disk, unless your disk is mirrored to the primary."


No, the disk was disconnected and therefore i expected that when i type in format. This line "c2t2d0 <Drive not available>" should not even appear.


The main reason i want to remove this line ""c2t2d0 <Drive not available>" is because i have a script that checks the output of the format command. If this line exists than it will pump out scsi not connected for that drive.

Also i have tried the command #drvconfig -c /dev/rdsk/c2t2d0s0

i couldnt see what this does?
 

10 More Discussions You Might Find Interesting

1. Linux

read removable disk

Hello I am trying to read from a small disk , 256 MB , removable sandisk.I am not able to access the device. The system does not recognise my disk to copy file s from the disk. Please post your solution in this issue. Thanks (2 Replies)
Discussion started by: singh85
2 Replies

2. Solaris

mounting an external scsi tape drive

hi- I just installed a quad gigaswift ethernet scsi card to my sunblade 150. I checked with the docs, and got all of the required drivers on the box. Now, I'm trying to mount an external scsi tape drive with no luck. I set the scsi address on the external drive to 0. Here's what I'm coming... (9 Replies)
Discussion started by: ECBROWN
9 Replies

3. UNIX for Dummies Questions & Answers

Connecting an external SCSI drive to a unix computer

I am interested in booting up my unix computer by connecting an external SCSI drive( intergraph) to it. The unix box is also an intergraph computer. Whenever I boot it, it gives me an error that says Drive not ready, Insert Boot Diskette in A. What am I doing wrong? Any input would be... (3 Replies)
Discussion started by: teruotor
3 Replies

4. UNIX for Dummies Questions & Answers

External SCSI hard drive

Someone gave me a small external SCSI hard drive for my SunOS 5.8 test system. How do I make Unix see the hard drive? (2 Replies)
Discussion started by: FredSmith
2 Replies

5. AIX

mirror external scsi to san

Hi, How do I mirror an external scsi vg to one hdisk san? The vg has multiple hdisks and the san hdisk has only one. Is this possible or do I need to create the same hdisks as the scsi? What I meant is, if the scsi vg has 10 hdisk then I need to create also 10 hdisk of san with the same... (6 Replies)
Discussion started by: itik
6 Replies

6. Solaris

Unix command to remove external SCSI harddrive

Hi All, I have an external scsi harddrive (HD) connected directly to the workstation. I understand when the external HD is connected and turned on, and type in "devfsadm" command. Unix will detect it but not mount the drive. So by typing in "format" command it will display the following: #... (6 Replies)
Discussion started by: tlee
6 Replies

7. UNIX for Dummies Questions & Answers

How to copy MBR from old harddrive to new harddrive?

How do I copy the master boot record from one harddrive to another or how to install just the MBR? (7 Replies)
Discussion started by: shorty
7 Replies

8. Solaris

removable flash drive

I have a removable usb flash drive which is visible below as no. 2 # rmformat Looking for devices... 1. Volmgt Node: /vol/dev/aliases/cdrom0 Logical Node: /dev/rdsk/c0t0d0s2 Physical Node: /pci@0,0/pci-ide@1f,1/ide@0/sd@0,0 Connected Device: HL-DT-ST DVD+-RW... (4 Replies)
Discussion started by: seyiisq
4 Replies

9. Solaris

Connect an External SCSI Hard Drive to Ultra 80

Guys, I have googled and checked this forum in detail and couldn't find any satisfactory answers for my problem. I am trying to connect a external SCSI hard Drive(Sea Gate) to a Ultra 80. I connected it powered it up and at OK prompt did : boot -r system comes up and complains about not... (6 Replies)
Discussion started by: ajnabi
6 Replies

10. Solaris

Solaris 8 - Removable hard disk

Hi Gurus, I have difficulty in configuring removable hard disk in Solaris 8. I have connected hard disk to machine but I do not know how to configure it. Kindly tell me, how should I configure it .. so that I can create a mount point on this and write files to them. Regards Srini (7 Replies)
Discussion started by: sri243
7 Replies
HD(4)							     Linux Programmer's Manual							     HD(4)

NAME
hd - MFM/IDE hard disk devices DESCRIPTION
The hd* devices are block devices to access MFM/IDE hard disk drives in raw mode. The master drive on the primary IDE controller (major device number 3) is hda; the slave drive is hdb. The master drive of the second controller (major device number 22) is hdc and the slave hdd. General IDE block device names have the form hdX, or hdXP, where X is a letter denoting the physical drive, and P is a number denoting the partition on that physical drive. The first form, hdX, is used to address the whole drive. Partition numbers are assigned in the order the partitions are discovered, and only nonempty, nonextended partitions get a number. However, partition numbers 1-4 are given to the four partitions described in the MBR (the "primary" partitions), regardless of whether they are unused or extended. Thus, the first logi- cal partition will be hdX5. Both DOS-type partitioning and BSD-disklabel partitioning are supported. You can have at most 63 partitions on an IDE disk. For example, /dev/hda refers to all of the first IDE drive in the system; and /dev/hdb3 refers to the third DOS "primary" partition on the second one. They are typically created by: mknod -m 660 /dev/hda b 3 0 mknod -m 660 /dev/hda1 b 3 1 mknod -m 660 /dev/hda2 b 3 2 ... mknod -m 660 /dev/hda8 b 3 8 mknod -m 660 /dev/hdb b 3 64 mknod -m 660 /dev/hdb1 b 3 65 mknod -m 660 /dev/hdb2 b 3 66 ... mknod -m 660 /dev/hdb8 b 3 72 chown root:disk /dev/hd* FILES
/dev/hd* SEE ALSO
chown(1), mknod(1), sd(4), mount(8) COLOPHON
This page is part of release 3.53 of the Linux man-pages project. A description of the project, and information about reporting bugs, can be found at http://www.kernel.org/doc/man-pages/. Linux 1992-12-17 HD(4)
All times are GMT -4. The time now is 07:29 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy