Sponsored Content
Full Discussion: IBM Hardware question
Operating Systems AIX IBM Hardware question Post 302159722 by bakunin on Friday 18th of January 2008 09:52:08 AM
Old 01-18-2008
The 44p Model 170 is a 1-CPU (POWER3-II) machine. You cann have 334MHz and 400MHz processors. The size of RAM is 256MB-2GB over a 128bit bus.

There is a "RS/6000 7044 Model 170 Technical Overview and Introduction" handbook, for instance here.

The machine is quite good as long as you do not need to install anything beyond AIX 5.1 (and maybe 5.2, i'm not sure about this), although it is a 64-bit-machine.

A (modern) alternative would be the Intellistations series, which are also low-priced deskside workstations designed for single-user purposes.

Hope this helps.

bakunin
 

9 More Discussions You Might Find Interesting

1. UNIX for Dummies Questions & Answers

Hardware question?

Does anyone know how to install a second Ethernet adapter on a Sun Sparc 10? (2 Replies)
Discussion started by: jskillet
2 Replies

2. HP-UX

newbie question about hardware for HP-UX 11.i

I've been asked by my copmpany to scour the web for a computer on which we can run HP-UX 11.i --- Is there a certain architecture type that I need or will any Compaq HP computer be fine for running HP-UX 11.i ?? Thanks!! (3 Replies)
Discussion started by: jalburger
3 Replies

3. UNIX for Dummies Questions & Answers

Hardware question

I would like to use my sunblade to firewall the connections to my desktop and laptop, these at the minute are on a wifi router. What is the best solution? (0 Replies)
Discussion started by: Kawakaze
0 Replies

4. UNIX for Dummies Questions & Answers

Hardware question

Folks; Is there a command to know if my hardware can run 64-bit or 32-bit? I'm trying to re-install SUSE 64-bit on one of our server but i'm not sure if this server hardware designed for 32-bit only or for both Any help? (14 Replies)
Discussion started by: Katkota
14 Replies

5. AIX

Hardware upgrade question

I have an IBM pseries 7028-6E1 server with a six drive bay that is currently plugged into the scsi backplane of the motherboard. I am going to install a PCIX Ultra320 scsi raid adapter, and swing the drive bay over to it. I am just wondering how this is going to work. Should I power the server... (1 Reply)
Discussion started by: markper
1 Replies

6. UNIX for Dummies Questions & Answers

Processor performance question [hardware]

A few of our machines need upgrading and we are looking into a selection of processors at present. There are suggestions on the vendor's websites that the L3 cache was specifically introduced for gamers. Is this true? Does having L1, L2 and/or L3 cache help at all in performance or are the... (0 Replies)
Discussion started by: figaro
0 Replies

7. Solaris

Which company's hardware is more stable, in case of IBM (AIX), HP (HPUX) & Sun (Solaris)

Hi guru I want to know which company's hardware is more stable means in term of H/W faults or replacement, in case of IBM (AIX), HP (HPUX) & SUN MICROSYSTEM (Solaris) & which order also, if we go through more stable to less stable system. Regards (1 Reply)
Discussion started by: girish.batra
1 Replies

8. AIX

New to AIX and IBM Hardware. Need some info

Hello all. I'm new to AIX and IBM hardware and I have a question around the configuration of the service processor on the power series. I need to know: 1) How do I get into the service processor from the serial console when AIX is up and running. I come from the Sun world and I tried all I know.... (1 Reply)
Discussion started by: glenc2004
1 Replies

9. High Performance Computing

IBM Hardware: Test speed of an execution core reliably.

Hey Folks, Doing simple floating point or integer arithmetic is limited since if another execution core is not busy, the system will (presumably?) assign CPU resources to where they are needed so I could be getting the performance of 2 or more cores theoretically? Any good reliable way to... (2 Replies)
Discussion started by: Devyn
2 Replies
mlib_ImageColorDitherInit(3MLIB)			    mediaLib Library Functions				  mlib_ImageColorDitherInit(3MLIB)

NAME
mlib_ImageColorDitherInit - initialization for image dithering SYNOPSIS
cc [ flag... ] file... -lmlib [ library... ] #include <mlib.h> mlib_status mlib_ImageColorDitherInit(void **colormap, const mlib_s32 *dimensions, mlib_type intype, mlib_type outtype, mlib_s32 channels, mlib_s32 entries, mlib_s32 offset, void **lut); DESCRIPTION
The mlib_ImageColorDitherInit() function creates an internal data structure, colormap, which can be used by one of the following functions for image dithering: mlib_ImageColorErrorDiffusion3x3 mlib_ImageColorErrorDiffusionMxN mlib_ImageColorOrderedDither8x8 mlib_ImageColorOrderedDitherMxN The lut might have either 1 or 3 channels. The type of the lut can be one of the following: MLIB_BYTE in, MLIB_BYTE out (i.e., BYTE-to-BYTE) MLIB_BIT in, MLIB_BYTE out (i.e., BIT-to-BYTE) If dimensions == NULL, then no colorcube will be created. In this case, the user-provided lookup table, lut, will be used for dithering. If dimensions != NULL, then a colorcube is created from scratch in a way shown in the following example. To dither an RGB image of type MLIB_BYTE to a color-indexed image of type MLIB_BYTE, we can use the following parameters: mlib_s32 dimensions[] = {2, 3, 4}; mlib_type intype = MLIB_BYTE; mlib_type outtype = MLIB_BYTE; mlib_s32 channels = 3; mlib_s32 offset = 6; These values would lead to the creation of a colorcube that would dither red values in the source image to one of 2 red levels, green val- ues to one of 3 green levels, and blue values to one of 4 blue levels. You could picture this colorcube as a cube with dimensions of 2, 3, and 4. The index values assigned to the elements in that cube can be described by the following lookup table: | | | Indexes | Red Values | Green Values | Blue Values ---------------+----------------+----------------+--------------- 0 | | | ---------------+----------------+----------------+--------------- ... | | | ---------------+----------------+----------------+--------------- 5 | | | ---------------+----------------+----------------+--------------- 6 | 0 | 0 |0 ---------------+----------------+----------------+--------------- 7 | 255 | 0 |0 ---------------+----------------+----------------+--------------- 8 | 0 | 128 |0 ---------------+----------------+----------------+--------------- 9 | 255 | 128 |0 ---------------+----------------+----------------+--------------- 10 | 0 | 255 |0 ---------------+----------------+----------------+--------------- 11 | 255 | 255 |0 ---------------+----------------+----------------+--------------- 12 | 0 | 0 |85 ---------------+----------------+----------------+--------------- 13 | 255 | 0 |85 ---------------+----------------+----------------+--------------- 14 | 0 | 128 |85 ---------------+----------------+----------------+--------------- 15 | 255 | 128 |85 ---------------+----------------+----------------+--------------- 16 | 0 | 255 |85 ---------------+----------------+----------------+--------------- 17 | 255 | 255 |85 ---------------+----------------+----------------+--------------- 18 | 0 | 0 |170 ---------------+----------------+----------------+--------------- 19 | 255 | 0 |170 ---------------+----------------+----------------+--------------- 20 | 0 | 128 |170 ---------------+----------------+----------------+--------------- 21 | 255 | 128 |170 ---------------+----------------+----------------+--------------- 22 | 0 | 255 |170 ---------------+----------------+----------------+--------------- 23 | 255 | 255 |170 ---------------+----------------+----------------+--------------- 24 | 0 | 0 |255 ---------------+----------------+----------------+--------------- 25 | 255 | 0 |255 ---------------+----------------+----------------+--------------- 26 | 0 | 128 |255 ---------------+----------------+----------------+--------------- 27 | 255 | 128 |255 ---------------+----------------+----------------+--------------- 28 | 0 | 255 |255 ---------------+----------------+----------------+--------------- 29 | 255 | 255 |255 ---------------+----------------+----------------+--------------- ... | | | The distance between level changes in each channel of the lookup table is determined by the following formulas: multipliers[0] = signof(dimensions[0])*1; multipliers[i] = signof(dimensions[i])* abs(multipliers[i-1]*dimension[i-1]); A negative dimensions[i], so as to a negative multipliers[i], indicates that the values in a color ramp for channel i should appear in decreasing as opposed to increasing order. For each channel i, the values of the levels are determined by the following formulas: double delta = (dataMax - dataMin)/(abs(dimensions[i]) - 1); int levels[j] = (int)(j*delta + 0.5); where dataMax and dataMin are the maximum and minimum values, respectively, for data type intype. Whenever a colorcube is created, if lut != NULL, the lookup table will be filled according to the colorcube and supplied parameters like offset. For the example shown above, the lookup table will start from line 6. In this case, it is the user's responsibility to allocate memory for the lookup table. PARAMETERS
The function takes the following arguments: colormap Internal data structure for image dithering. dimensions Dimensions of the colorcube in the colormap structure. intype Data type of the source image and the lookup table. outtype Data type of the destination indexed image. channels Number of channels of the lookup table and source image. entries Number of entries of the lookup table. offset Index offset of the lookup table. lut Lookup table. RETURN VALUES
The function returns MLIB_SUCCESS if successful. Otherwise it returns MLIB_FAILURE. ATTRIBUTES
See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Interface Stability |Committed | +-----------------------------+-----------------------------+ |MT-Level |MT-Safe | +-----------------------------+-----------------------------+ SEE ALSO
mlib_ImageColorDitherFree(3MLIB), mlib_ImageColorErrorDiffusion3x3(3MLIB), mlib_ImageColorErrorDiffusionMxN(3MLIB), mlib_ImageColorOrdered- Dither8x8(3MLIB), mlib_ImageColorOrderedDitherMxN(3MLIB), attributes(5) SunOS 5.11 2 Mar 2007 mlib_ImageColorDitherInit(3MLIB)
All times are GMT -4. The time now is 07:23 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy