rmcp_ping(1) [debian man page]

rmcp_ping(1)						      IPMI RMCP Ping program						      rmcp_ping(1)

NAME

       rmcp_ping - IPMI RMCP Ping program

SYNOPSIS

       rmcp_ping [-p port] [-t waittime] [-s starttag] [-d] destination

DESCRIPTION

       The rmcp_ping program sends an RMCP ping packet onces a second to the destination, printing unique responses it receives.

OPTIONS

       -p port
	      Set the destination port.  This is the standard RMCP port by default, 623.

       -t waittime
	      Sets the number of seconds to wait for a response.  Ten by default.

       -s starttag
	      There  is  an  8-bit tag value in every ping packet (0-254, 255 is reserved), this program will cycle through the values starting at
	      starttag.  This is zero by default

       -d     Turns on debugging to standard output.

       destination
	      The target address, default is the boradcast address (default 255.255.255.255)

AUTHOR

       Corey Minyard <cminyard@mvista.org>

OpenIPMI							     02/24/06							      rmcp_ping(1)

RMCPING(8)						      System Manager Commands							RMCPING(8)

NAME

       rmcpping - send RMCP Ping to network hosts

SYNOPSIS

       rmcpping [OPTION...] destination

DESCRIPTION

       rmcpping  uses  the  RMCP  Ping request datagram to elicit an RMCP Pong response from a remote host. The utility can be used to verify if a
       remote host supports RMCP or IPMI. The initial starting sequence number will be randomized.  rmcpping will return 0 to the  environment	if
       it receives atleast 1 response from the remote host. Otherwise, it exits with a value of 1.

OPTIONS

       The following options are available

       -h     Output help menu.

       -V     Output version.

       -c count
	      Stop after sending count packets.

       -i interval
	      Wait interval seconds between sending each packet. The default is to wait for one second between each packet.

       -I interface address
	      Set source address to specified interface address. Argument may be numeric IP address or name of device.

       -t timeout
	      Time to wait for a response, in seconds. Default is five seconds.

       -v     Verbose output.

       -s num Specify an initial starting sequence number. The default is to use a random initial sequence number.

       -d     Turn on debugging.

KNOWN ISSUES

       It has been observed that some remote BMCs can get "confused" and delay packet responses if duplicate packets (with duplicate sequence num-
       bers) are sent in succession very quickly. There is no known way to cleanly deal with a "confused" BMC other than the wait awhile.

       Unlike ping(8), local network devicess (e.g. 127.0.0.1) cannot be "pinged".

REPORTING BUGS

       Report bugs to <freeipmi-users@gnu.org> or <freeipmi-devel@gnu.org>.

COPYRIGHT

       Copyright (C) 2007-2012 Lawrence Livermore National Security, LLC.
       Copyright (C) 2003-2007 The Regents of the University of California.

       This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as  published	by
       the Free Software Foundation; either version 3 of the License, or (at your option) any later version.

ORIGIN

       Command and manpage based off ping(8).

SEE ALSO

       freeipmi(7), ping(8), ipmiping(8)

       http://www.gnu.org/software/freeipmi/

rmcpping 1.1.5							    2012-06-15								RMCPING(8)