10 More Discussions You Might Find Interesting
1. Solaris
How to setup rcp in Solaris (4 Replies)
Discussion started by: VIJAYA BABU A
4 Replies
2. Solaris
Hi all, I have setup Solaris 10 OS on my home Sparc (Blade 1500) box. I also setup CDE (Common Desktop Environment).
The box has Network card with 6 connections available for Internet, So I hooked up a hard-wired link from my router to the first slot. The light is green on both ends.
Now, how... (2 Replies)
Discussion started by: steve701
2 Replies
3. Solaris
I have a solaris 10 on my laptop. I want to let my internet work.
Command: ifconfig -a
Return:
lo: ...
e1000g0: ...
I dont know what else to setup so when I open firefox, I have access to internet. Can anyone show me how to do the setting? Thanks a lot. (1 Reply)
Discussion started by: dbahaha
1 Replies
4. Solaris
Please someone help me to setup HP Cp3505n running with Solaris 10.
Thanks so much! (3 Replies)
Discussion started by: Caktus
3 Replies
5. Solaris
Hi All,
How do I setup exceed on solaris 10 either sparc or intel? When I ssh or telnet and exceed is already running? Nothing comes out when I run smc.
Thanks in advance,
itik (0 Replies)
Discussion started by: itik
0 Replies
6. Solaris
Can you use the new OpenSwan IPsec on Solaris? Or what software does Sun provide for Windows-Solaris integrated VPNs?
Thanx. :D (0 Replies)
Discussion started by: Joncamp
0 Replies
7. UNIX for Dummies Questions & Answers
I installed solaris 10 x86 on my dell laptop on a partition alongside windows xp. I am able to connect to the internet in xp with both my ethernet local area connection as well as through my wireless network card. But, however i do not have clue as to how to go about it in solaris.
i did not... (0 Replies)
Discussion started by: stakes20
0 Replies
8. Solaris
I,am trying to configure an external multitech 5656zdx modem for dial in mode on a serial port using a dell 1800 server with solaris 10 for intel as the OS. It answers only once, further attemps fail, I have to reboot system before it will
work again. I also used an older model 3334zdx which... (1 Reply)
Discussion started by: albm
1 Replies
9. UNIX for Dummies Questions & Answers
I need help with the new modem. The following has been done:
Installed the modem in the 6th PCI slot
Setup COM2 for:
> 38400 (baud rate)
> Modem - Dial out Only (template)
Ran:
#tip /dev/cua/b
connected
The console stops responding at this point. HELP! :(
////////// --... (2 Replies)
Discussion started by: mslightn
2 Replies
10. UNIX for Dummies Questions & Answers
I have a HP laserjet 5Si MX on a Microsoft network that I need to route my print output to. I have setup a host that amounts to just the ip address of the printer, and created a printer that is connected to that host. My print is sent directly to the printer, but it is not formatted correctly. ... (2 Replies)
Discussion started by: pkappaz
2 Replies