9 More Discussions You Might Find Interesting
1. Linux
Hello Admins,
My ask is how can I add two different subnet IPs to same box with two different gateways?
The issue is I can connect to the box when I am on ethernet LAN, but I am not able to connect to the same IP when I am on wifi. The server is RHEL 7 VM on vmware.
How can I get connected... (4 Replies)
Discussion started by: snchaudhari2
4 Replies
2. Linux
So I'm having a problem getting a Broadcom BCM4312 wireless controller to work under the broadcom-wl module
$uname
Linux 3.8.11-200.fc18.x86_64 #1 SMP Wed May 1 19:44:27 UTC 2013 x86_64 x86_64 x86_64 GNU/Linux
lspci -v
05:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g... (2 Replies)
Discussion started by: Skrynesaver
2 Replies
3. Solaris
I'm having the hardest time finding the Broadcom drivers for Solaris. I need an odd ball, 32-bit for Solaris 10. Anyone know where I can find one? (0 Replies)
Discussion started by: Ihatewindows
0 Replies
4. Red Hat
Dear All
I want tune my NIC's rps, rfs and xps value.
In my system I have two NIC (eth0, eth1) and I have a bond0 ( eth0, eth1).
Here is the question? Which device should I modify ?
eth0 and eth1? or just modify bond0 or modify all device (eth0, eth1, bond0)
Any advice is welcome.... (0 Replies)
Discussion started by: nnnnnnine
0 Replies
5. IP Networking
I am new in squid proxy.
My question is how to (and if it's necessary) to set one NIC for inbound traffic (http requests) and one NIC for outbound traffic (http answers)?
Thank you in advance! (4 Replies)
Discussion started by: aixlover
4 Replies
6. Solaris
I couldn't install my nic in solaris 10. I compiled and added
the driver but failed to attach the driver and ifconfig output
shows only loopback dev. Please see the following output and tell
me whether my nic has been detected and why the driver failed to
attach?
My nic is detected in linux... (0 Replies)
Discussion started by: vectrum
0 Replies
7. BSD
Is there a way to configure Broadocom wifi 4312 in a bsd system, FreeBSD or OpenBSD. I will appreciate any kind of help.
Thanks in advance (1 Reply)
Discussion started by: piukeman
1 Replies
8. Solaris
Hi to all,
I've installed Solaris 10 on my workstation but I've some networks problems.My NIC,a Broadcom integrated chipset don't work with solaris.Whit the prtconf command I'm unable to identify the correct chipset's model.And I'm searching hovewer for some drivers but I'm fear that Broadcom... (2 Replies)
Discussion started by: bgf0
2 Replies
9. UNIX for Advanced & Expert Users
Hi guys,
i must install an old old old ml370 server...
I must create a RAID 5 with my 4 SCSI disk.
I need a SmartStart disk for create it or a Floppy Disk called "Array configuration Tool". I don't find it on the hp website...:mad::mad::mad:
Anyone have it??
Thanks in advance.
Zio (0 Replies)
Discussion started by: Zio Bill
0 Replies