I've created a partition with GNU Parted, how do I mount the partition?


 
Thread Tools Search this Thread
Top Forums UNIX for Dummies Questions & Answers I've created a partition with GNU Parted, how do I mount the partition?
# 1  
Question I've created a partition with GNU Parted, how do I mount the partition?

I've created a partition with GNU Parted, how do I mount the partition?

The manual information at http://www.gnu.org/software/parted/manual/parted.html is good, but I am sure about how I mount the partition afterwards.

Thanks,

--Todd
# 2  
Helo. It's been a long time since I last used parted, but the steps should be:
- Create a partition.
- Create a file system.
- Create a mount point, if it does not already exist, and
- mount it: mount /dev/<partitionname> /mount/point
Regards.
 

Previous Thread | Next Thread
Thread Tools Search this Thread
Search this Thread:
Advanced Search

Test Your Knowledge in Computers #713
Difficulty: Medium
The shared bus between the program memory and data memory leads to the von Neumann bottleneck, the limited throughput (data transfer rate) between the CPU and memory compared to the amount of memory.
True or False?

10 More Discussions You Might Find Interesting

1. AIX

Can't mount a partition

Hello, today i get some aix errors (can't lock files and strange things) then i umount FS to do a fsck but i get these errors root@omega / > fsck -p /dev/fslv06 The current volume is: /dev/fslv06 Unable to read primary superblock. Unable to read either superblock. I readed on this page... (9 Replies)
Discussion started by: thorin666
9 Replies

2. Red Hat

Shrink LVM partition & create new Linux Primary partition

Hello All, I have a Red Hat Linux 5.9 Server installed with one hard disk & 2 Partitions created on it as follows, /boot - Linux Partition & another is LVM - One VG & under that 5-6 Logical volumes(var,opt,home etc). Here my requirement is to take out 1GB of space from LVM ( Any logical... (5 Replies)
Discussion started by: gr8_usk
5 Replies

3. Solaris

Partition overlaps another partition while creating new parition in solaris

hi all while formatting hard disk i am getting following error. Partition 1 ends at 266338338 It must be between 34 and 143374704. label error: EFI Labels do not support overlapping partitions Partition 8 overlaps partition 1. Warning: error writing EFI. Label failed. I have formatted the... (2 Replies)
Discussion started by: nikhil kasar
2 Replies

4. Shell Programming and Scripting

Partition with parted

Hello folks, I have 2.4TB san storage i want to make 4 partition each having 600GB. I use fdisk but not possible to do this because of fdisk limitation. So i tried parted but it make 2.4TB one partition but with parted not possible to make 4 partition having 600GB, may be i m doing wrong, can... (6 Replies)
Discussion started by: learnbash
6 Replies

5. Solaris

no command works after i created new partition!!!

This was my intial setup of the partition table. Part Tag Flag Cylinders Size Blocks 0 root wm 259 - 2666 4.70GB (2408/0/0) 9863168 1 swap wu 3 - 258 512.00MB (256/0/0) 1048576 2 backup wm 0 -... (8 Replies)
Discussion started by: chidori
8 Replies

6. UNIX for Dummies Questions & Answers

mount extended partition

Hello, Im new here, and may be my question is stupid, but... Today I run PGP Desktop decript on my 2nd partition ( D:\ ) and when decript finish, I restart my PC.Now when I try to open D:\ its give me: D:\ is not accessable and I lose my files :( So I load Linux live CD ( knoppix ) and try to... (1 Reply)
Discussion started by: mrowcp
1 Replies

7. Filesystems, Disks and Memory

Partition management: lvm? fdisk? parted? (on RAID)

Hello, I have a RHEL system with two 500GB hard drives in RAID 1 (I think hardware, but not 100% certain - any way to tell?). It looks like it was just set up in default configuration with a small boot partition and one huge partition for the rest, which composes a LVM volume. I want... (1 Reply)
Discussion started by: builder88
1 Replies

8. Solaris

Created a partition and modified vfstab, recieve error after reboot

Hi there Should mention, I am Oracle DBA. Installed Solaris 10 on VM Ware. Created a partition, no hassle there. Modified vfstab, but made a typo, after reboot, received error message. See attached... Any ideas, be greatly appreciated. (2 Replies)
Discussion started by: Ackers
2 Replies

9. Solaris

how to mount other partition?

dear all, that is my problem : c0d0p1 is nt, c0d0p2 is solaris and other on extended partition is pcfs, so how can i mount it somewhere? because i dont know which one connect from raw to block dev. /dev/rdsk/c0d0p? any help would be great... :) (6 Replies)
Discussion started by: stdout
6 Replies

10. Solaris

can't mount a partition

Hello, I have a problem on my sun station, that run solaris7. To free temporarly a little space on /, I moved a few empty folders (mnt, net, awk, tftpboot) to the /home partition. Unfortunately the system froze just after this…maybe I should not have move this files, I don't know, I am a... (3 Replies)
Discussion started by: nabulus
3 Replies

Featured Tech Videos