8 More Discussions You Might Find Interesting
1. What is on Your Mind?
Ten movies have been nominated as best motion picture by the International Press Academy, presentation of the 2012 Satellite Awards will be held on 16th December at Los Angeles, CA.
Place your bits here on one of the below nominated movie of your choice:-
Argo
... (0 Replies)
Discussion started by: Yoda
0 Replies
2. UNIX for Dummies Questions & Answers
people i have a problem i have a 32 bits sparc processor, and solaris 64 bits processor, i install a oracle data base 64 bits, but my oracle will not run because my processor is from 32 bits this is ok??, i know if i have x86 i cannot install a 64 bits operatin system in a 32 bits processor.
... (0 Replies)
Discussion started by: enkei17
0 Replies
3. AIX
Guys...
Hows it going???
I have been going through the hardware spec of IBM system p systems.. and here i am confused
for IBM Power 520 Express it says
Processor cores:
One, two or four 64-bit 4.2 GHz POWER6 with AltiVec™ SIMD and Hardware Decimal Floating-Point acceleration
... (1 Reply)
Discussion started by: balaji_prk
1 Replies
4. AIX
Hello there:
I know that exist a procedure to convert an OS using 32bits kernel to 64 bits kernel. But, exist a procedure to convert an OS using 64bits to 32 bits kernel?
Please help me.
Regards. (2 Replies)
Discussion started by: GEIER
2 Replies
5. AIX
Question is on setting of Physical and Virtual processors for LPARs to make proper use of virtualization capabilities.
Environment is a 8-way p570 with 4 LPARs.
lparVIO1 and lparVIO2:
AIX 5300-04-01
Mode/Type= Shared-SMT/Capped
Minimum Processors= 0.10
Desired Processors= 0.50
Maximum... (1 Reply)
Discussion started by: guttew
1 Replies
6. UNIX for Dummies Questions & Answers
Hi Friends,
The command to check the processor bits is :
getconf KERNEL_BITS
but this is not working in ksh.
Is there any other alternate command that can be used for the same purpose . (4 Replies)
Discussion started by: Rohini Vijay
4 Replies
7. UNIX for Dummies Questions & Answers
Hello all,
I was wondering if anyone can tell me how to change 24 bits depth display to 8 bits depth display for Sun Ultra1, running Solaris 8? THANKS in advance. I think that the command is ffbconfig, but it has nothing about depth. (4 Replies)
Discussion started by: larry
4 Replies
8. UNIX for Dummies Questions & Answers
From a PROM ok prompt I have typed banner. This returned this info
SunSPARCStation20 (1X390Z50) ......
Okay, I read that the 1x390z50 is the processor type. How can I found out the speed of these processor? Is it 50mhz? Don't know but I am curious. Thanks (5 Replies)
Discussion started by: jwbrown
5 Replies