9 More Discussions You Might Find Interesting
1. IP Networking
Hello. I want to Communicate 2 VLAN with router like this solution:
http://8pic.ir/images/83m0ouih8mmm9s1sfl56.jpg
For this purpose I'm configuring 2 Linux system as a switch and connect 4 host to them. Then a router is added to scenario.
The configuration of the switches is:
On DUT1(Linux):... (1 Reply)
Discussion started by: zsn
1 Replies
2. Programming
nmap is a network utility which gives u information about open ports on ur system. for eg
$ nmap 10.226.112.202
PORT STATE SERVICE
7/tcp open echo
13/tcp open daytime
22/tcp open ssh
23/tcp open telnet
37/tcp open time
1100/tcp open unknown
these open... (2 Replies)
Discussion started by: anand121
2 Replies
3. UNIX for Dummies Questions & Answers
I am running a solaris 10 box and is just a workstation. I want to turn off the message below since it is annoying me.
Nov 15 12:16:07 stage5 in.routed: discard RIP response; source 134.56.105.2 not on interface eri0
This message only pops up when I am in a console. Telnet doesn't see it.
... (2 Replies)
Discussion started by: tecky
2 Replies
4. Linux
Hello All,
I know it's a tricky probably stupid question but I'm stuck.... :(
Is there any way to route different protocols through different eth cards for the same destination in Linux? With route add or something like it?
For instance:
FTP to/from 192.168.1.1 goes through eth0 - gw2... (1 Reply)
Discussion started by: pmpx
1 Replies
5. Linux
how i add new routes to my linux machine (1 Reply)
Discussion started by: youmna
1 Replies
6. AIX
i have AIX Unix with "dynamic routing table" service enabled, but i do not need this service. How i can disable this service.
thanks (1 Reply)
Discussion started by: jdsnbr
1 Replies
7. Red Hat
I have just recently got into using Linux RedHat 9. So far I love it, I have set it up on a server I am running. Right now I have set up Samba and am running a file server for my house. I have four computers, the linux box is connected to the internet through a switch I have. There are two NICS in... (1 Reply)
Discussion started by: xTHESEUSx
1 Replies
8. Red Hat
:mad: I have just recently got into using Linux RedHat 9. So far I love it, I have set it up on a server I am running. Right now I have set up Samba and am running a file server for my house. I have four computers, the linux box is connected to the internet through a switch I have. There are two... (5 Replies)
Discussion started by: xTHESEUSx
5 Replies
9. Linux
How to use NAT Router in linux Redhat 6 ? and what
packages and configuration are required ? (1 Reply)
Discussion started by: salhoub
1 Replies