8 More Discussions You Might Find Interesting
1. Red Hat
Dear Expert,
I 've installed Redhat linux AS3, My machine having Inbuild network card (Intel(R) 82566DM-2 Gigabit Network Connection).
I've downloaded e1000e-2.3.2 from Intel site, but its not working for my machine. I'm unable to configure the Network.
ifconfig eth0 xx.xx.xx.xx netmask... (0 Replies)
Discussion started by: Mohammed Faiz
0 Replies
2. Programming
Hi
on multi-core system - I know I can set each process to run on specific core (Processor Affinity).
If I want to set process (which contains several threads) to run on group of core, how can I do it ?
For example:
If we have 8 core,
and two process each process contain 4 threads.
And I... (2 Replies)
Discussion started by: laro1983
2 Replies
3. Solaris
I want to know how can in Solaris i can:
>Set Process priority to maximum
>Set Process Affinity.
Linke in windows task manager we can set process priority to following levels:
Low, Below Normal,Normal , Above Normal , High , Realtime
And we can set process affinity to run on all processors.... (10 Replies)
Discussion started by: mr_os
10 Replies
4. AIX
Guys...
Hows it going???
I have been going through the hardware spec of IBM system p systems.. and here i am confused
for IBM Power 520 Express it says
Processor cores:
One, two or four 64-bit 4.2 GHz POWER6 with AltiVec™ SIMD and Hardware Decimal Floating-Point acceleration
... (1 Reply)
Discussion started by: balaji_prk
1 Replies
5. Red Hat
Hi,
After a reboot, One of My Proliant Machine DL380 could not load the O/S.
Raid 1+0 was configured.
Some Gathered Facts:
During Boot from System Rescue, the following message appears
"You don't have any linux partitions.Press return to get a shell. The system will reboot... (1 Reply)
Discussion started by: Muhammad Ahmad
1 Replies
6. AIX
Question is on setting of Physical and Virtual processors for LPARs to make proper use of virtualization capabilities.
Environment is a 8-way p570 with 4 LPARs.
lparVIO1 and lparVIO2:
AIX 5300-04-01
Mode/Type= Shared-SMT/Capped
Minimum Processors= 0.10
Desired Processors= 0.50
Maximum... (1 Reply)
Discussion started by: guttew
1 Replies
7. Programming
In attachment, is the code to test IP by ARP proxy. I always use it to test a IP already existing in my cluster.
Usage:
arp_func eth0 192.168.1.1
Enviroment:
IA64, RedHat AS3.0, 2.4.21-15.EL, gcc-3.2.3-34,
"gcc -o arp_func arp_func.c"
When the code below added before... (0 Replies)
Discussion started by: lameryang
0 Replies
8. Linux
hello all,
I was wondering if anyone had setup XDMCP client and server on thier Rehat AS3. I remember that it redhat 9 you just needed to enable XDMCP. Then you would get the chooser and enable you to connect to another X server. I was looking at this and reconfigure the xdm-config file, but... (0 Replies)
Discussion started by: larryase
0 Replies