The top(1) command will show what processes are running on what processor.
You will have to tell us what flavour of Unix you are running at which point an expert on that flavour will tell you what can be done about running on a particular processor?
I am running on linux system. I have tried using top ( could not understand what the output meant).
What I want to know is how to run commands on different processors ( I think I will be able to do that using rsh but for that I need to know their name or id right??)
I am not able to use mpstat it says command not found.
I know I have 8 processors, found that using this command
$ cat /proc/cpuinfo |grep processor | wc -l
If the copy of top is multi-processor aware the process will show which CPU it is running with a slash and a number, that number being which processor the process is running on.
If mpstat is on your system somewhere then "locate(1)" will find it, you may have to run updatedb(8) first, so try running:
mpstat will show the loading for each processor (or the cpu you have selected depending on the version of mpstat) but not what is running on each processor.
Don't forget that the operating system should spread the load across the processors for you so you should not need to select which processor your process should run on.
Last edited by TonyFullerMalv; 05-17-2009 at 12:33 PM..
hi,
what plugins i need to install to run m4 processor in bash shell. Also, what is the file extension for m4 processor ( like .cc in c ).
Thanks (1 Reply)
Guys...
Hows it going???
I have been going through the hardware spec of IBM system p systems.. and here i am confused
for IBM Power 520 Express it says
Processor cores:
One, two or four 64-bit 4.2 GHz POWER6 with AltiVec™ SIMD and Hardware Decimal Floating-Point acceleration
... (1 Reply)
Question is on setting of Physical and Virtual processors for LPARs to make proper use of virtualization capabilities.
Environment is a 8-way p570 with 4 LPARs.
lparVIO1 and lparVIO2:
AIX 5300-04-01
Mode/Type= Shared-SMT/Capped
Minimum Processors= 0.10
Desired Processors= 0.50
Maximum... (1 Reply)
Hi Everyone
I am new to unix. I ahve few quries that i would like to post.
Is there any way by which i get the unique processor Id. Actually i am unable to find any logic and method to get access to Processor Id.
Is it possible to get it. I read it on Intel site that the new processor do no... (1 Reply)
hello World
I Hope to know Why AIX don't Run under INTEL Processor ??
If Any Project Is expected to make AiX to run Under INTEL Processor ???
Thank you ALL (3 Replies)
From a PROM ok prompt I have typed banner. This returned this info
SunSPARCStation20 (1X390Z50) ......
Okay, I read that the 1x390z50 is the processor type. How can I found out the speed of these processor? Is it 50mhz? Don't know but I am curious. Thanks (5 Replies)