9 More Discussions You Might Find Interesting
1. Red Hat
Hello community, after hours (days) spent to understand what's the problem reported also in the following thread: https://www.unix.com/red-hat/278892-cant-boot-rhel7-2-due-start-job-running.html
I realize that the problem is the server itself. I opened a new thread since the issue in not related... (2 Replies)
Discussion started by: Lord Spectre
2 Replies
2. Red Hat
Dear all ,
i ve configured raid 0 in redhat machine(VM ware), by following steps:
#mdadm -C /dev/md0 -l 0 -n 2 /dev/sdb1 /dev/sdc1
#mkfs.ext3 /dev/md0
#mdadm --detail --scan --config=mdadm.conf >/etc/mdadm.conf
then
mounted the/dev/md0 device and also added a entry in fstab.
how... (2 Replies)
Discussion started by: sriniv666
2 Replies
3. UNIX for Dummies Questions & Answers
Is it possible for both commands to work? (1 Reply)
Discussion started by: phunkypants
1 Replies
4. Emergency UNIX and Linux Support
One of my very old drive farm servers had an OS fault and can't boot now but I'd like to restore some files from it. I tried booting Ubuntu from a CD, but it couldn't see the drives -- possibly because they're RAIDed together. Is there a good way to get at my files?
The data in question is a... (2 Replies)
Discussion started by: CRGreathouse
2 Replies
5. Shell Programming and Scripting
Hi,
I wish to store $string1 in $string1array a character in each array element.
Then i wish to echo the entire array to the screen so that it reads as the normal string again.
I have been trying with the code below but does not work. Please help...
To put string into array:
... (5 Replies)
Discussion started by: rorey_breaker
5 Replies
6. UNIX for Advanced & Expert Users
Hi, there are tons of RAID1 tutorials, but none of them deal with lvm. The problem is that I want to expand my current lvm partition over RAID1 rather than creating a new lvm partition after RAID1 is created.
My master harddrive has lvm partition. I'm wondering how to create a RAID1 image of... (1 Reply)
Discussion started by: onthetopo
1 Replies
7. AIX
I created a RAID 5 array and when I list out the attributes of the "hdisk" it reports back raid_level = 5 but the RAID level of the array = false. What does this actually indicate about my array? I've never paid much attention to this until now since I have a disk reporting failure I want to make... (0 Replies)
Discussion started by: scottsl
0 Replies
8. UNIX for Advanced & Expert Users
I have a new Rp4440 that has hp-ux 11.11 on it with a smart array 30 attached to it, HP says they are compatiable and i should be able to use it. I am looking for any help in setting up the array i have it all connected but dont know how to setup the array so the OS see's hard drives. I got no... (1 Reply)
Discussion started by: marvin51796
1 Replies
9. SCO
Trying to install Sco openserver on HP Proliant with this scsi controller but no scsi devices detected.
Boot controller is set as the smart array 532 but SCSI diags do not detect any SCSI boot devices during boot sequence
Any help appreciated (2 Replies)
Discussion started by: farmacy
2 Replies