9 More Discussions You Might Find Interesting
1. UNIX for Advanced & Expert Users
so i have many scripts that have to run when the bash source is installed as normal.
however, some users have found a way to build bash from source and while doing so, they altered some default settings.
my question is, what can i put in my script to check that the "flags.c" binary and... (6 Replies)
Discussion started by: SkySmart
6 Replies
2. UNIX for Dummies Questions & Answers
I'm rebuilding my primary computer at work tomorrow. Currently, it has Windows 7. I would like to replace the main system with either Linux or Unix, although I would like to be able to run a fully operational Windows as a VM within that. Any recommendations on which Linux or Unix to go with?
I'm... (6 Replies)
Discussion started by: Sean_
6 Replies
3. SCO
Hi, I am a new Unix Guru with very little experience but have the task of P2Ving an old HP Proliant ML370 G5 server to VMware ESX 4.1 or ESXi 5.5.
System seems to boots fine but when trying to remove HP software, configure TCP/IP or a driver, I am receiving:
--------
... (7 Replies)
Discussion started by: dj_Italian
7 Replies
4. Linux
Hi everyone,
I am trying to prevent the ehci_hcd kernel module to load at boot time.
Here's what I've tried so far:
1) Add the following line to /etc/modprobe.d/blacklist.conf (as suggested here):
2) Blacklisted the module by adding the following string to
3) Tried to blacklist the module... (0 Replies)
Discussion started by: gacanepa
0 Replies
5. AIX
Hi Guru's,
I'm trying to rebuild a very old HMC 7315-C02 the hard disk has gone so needs replacing. I've managed to find an old IDE hard disk lying around but its obvious that it's had windows running on it as the HMC install disks won't recognise the format. I'm trying to install HMC V6 R1.2... (3 Replies)
Discussion started by: elcounto
3 Replies
6. Solaris
Hi gurus
Could anybody tell me which file is read by kernel to set its default system kernal parameters values in solaris. Here I am not taking about /etc/system file which is used to load kernal modules or to change any default system kernal parameter value
Is it /dev/kmem file or something... (1 Reply)
Discussion started by: girish.batra
1 Replies
7. Red Hat
The crisis is over. I am just doing postmortem on how we handled it. So this is just an exercise in academics.
We have a mission critical system running on RED Hat Linux. It is a turnkey system "managed 100% by the vendor". I put this is quotes because we had an event last night that... (0 Replies)
Discussion started by: Skyybugg
0 Replies
8. Linux
I can't find a source rpm for a particular tool that I'm trying to modify. I can only get a hold of the noarch and tar.bz2. Can I modify either one of these and re-package them as a noarch.rpm? (2 Replies)
Discussion started by: eur0dad
2 Replies
9. UNIX for Dummies Questions & Answers
How would I rebuild the sun solaris kernel to include my new Oracle paramters? (3 Replies)
Discussion started by: jigarlakhani
3 Replies