Dear community,
I'm in trouble with Red Hat Server 5.8. After rebooting the server, I loose two interfaces used for bond2 (eth4 and eth5). I reboot twice the server but the result is always:
Previously I can seen the interfaces under:
Could you please help to restore the eth4 and eth5 ?
Thank you, Lucas
---------- Post updated at 05:52 AM ---------- Previous update was at 05:00 AM ----------
DAMN! Solved!
I missed HWADDR (MAC) config only on eth4 and eth5... Now tmp device are gone and bond2 is UP!
Sorry for wasting forum space, I hope this can be usefull to someone else, I guess HWADDR must be present on all interfaces!
Last edited by Lord Spectre; 07-04-2016 at 07:21 AM..
This User Gave Thanks to Lord Spectre For This Post:
Hi,
I am facing an issue with one of the 10G fiber link. After certain packets received. I am seeing errors in ifconfig eth* output.
MTU is set to 9000.
any idea? (1 Reply)
hi guys
I have a server which has 2 nics eth0 and eth1
eth0 is used for our email traffic server. everything working fine
some time later a eth1 was added for backup purposes so this new nic sends data to another vlan for backup purposes
all of a sudden our mail server starts to fail... (3 Replies)
I want to run dhcpclient for all the eth* which has no ip
for example
eth0 Link encap:Ethernet HWaddr 00:1E:67:3E:BA:EF
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0... (6 Replies)
Hi Al,
In course of understanding networking in Solaris, I have these doubts on Interfaces. Please clarify me. I have done fair research in this site and others but could not be clarified.
1. In the "ifconfig -a" command, I see many interfaces and their configurations. But I see many... (1 Reply)
Hi,
I created a new vdisk and presented it to a BL460c class server. The LUN was successfully created and presented.
My problem however is that I am unable to see the newly added LUN on my OS? I have rebooted the box but no joy.
Just wondering if you have any ideas on how this can be... (5 Replies)
Hi people,
I have a solaris OS system. I configured its interfaces. They are UP but not in RUNNING status except loopback interface. I made the interfaces DOWN and UP again. The other side of the interfaces (switch ports) are UP. Does anyone have any idea? What may cause this problem, How can I... (1 Reply)
folks;
This might sounds stupid but i hope someone can give me an answer:
On my Linux SUSE boxes, i have 2 NIC cards NIC1 & NIC2. I always assumed that NIC1 is eth0 when i run "ifconfig" and NIC2 is eth1
but i noticed that's not always the case.
Is there a way or a command i can run to find... (1 Reply)
Hi
I had a DL380 with two two port eth cards. I now replaced one with a four port eth card and my interfaces seemed to have jumped around.
Is there a method of moving eth ports... eg making port eth4 eth2.:confused: (2 Replies)
HI,
When I do 'service network restart' , I am getting the following error.
"3c501 device eth0 does not seem to be present, delaying initialization"
Can any one suggest me the cause/solution for this?
When I do 'lspci' it is showing the ehternet card as
" Ethernet controller"Marvell... (2 Replies)