Hope someone can help with this problem. We are running Solaris 10 with a current kernel patch of 142900-09.
We appear to be getting a serious issue with the routing table as shown below:
Output from netstat -rnv
At random intervals access to the 136 subnet fails. when examined the output of netstat -rnv has changed as follows:
The 136.254 route appears to have 'moved' up the table and is now the 'default' route for all 136 subnet traffic.
Removing and re-adding this route restores the order of the routing table as shown in the first example.
Has anyone else encountered a similar problem and if so how was it fixed or is it still an issue.
Currently we intend to write a checking script to log the details (output of netstat -rnv, ifconfig -a and route get) and then fix the issue.
We have checked the messages file for hardware failures and found nothing.
Please let me know if further information would help. (sorry about the extra .'s in the table).
Last edited by fpmurphy; 02-18-2011 at 01:09 AM..
Reason: code tags please!
how do I make sure that the entry in the routing table on Solaris 8 stay permanent after rebooting the server.
For example
route add 172.20.1.60 -netmask 255.255.255.0 172.20.255.253
Each time the server reboots the entry disappears when using the command netstat -nr (2 Replies)
Does anyone know how to delete a an ip off the routing table ? i tried route delete 10.0.0.0 and gateway but it still comes back. i have 2 zones sharing one interface. help... (4 Replies)
Hi all,
I am confusing with routing table, i use linux and iptables.
i have 1 internet gateway, and 1 router for VPN.
here is my network.
eth0=192.168.0.1
eth1=192.168.100.1
192.168.0.0/24 --- eth0(Linux Box)eth1 ---(DSL)---Internet
|
... (4 Replies)
hi all...
i need to know, where is locate the routing table on sun solaris, how i can saved the configuration....
because when i restart the server, lost the configuration....
thank you...
Regards... (3 Replies)
Is ther a way to retain say, a default gateway entered in a routing table after a reboot? I end up always having to re-enter my default gateway after I reboot my system.
Thanks! (4 Replies)
Hi,
I'm trying to connect to a network device, with the connection follwoing the UNIX routing table we set up. Its to go via a specific network Gateway and out throught a specific Lan card (Lan4). However when trying to conenct it keeps going through Lan3 and will not get to its destination.... (3 Replies)