Novell Responds to SCO's Objections to its Bill of Costs

 
Thread Tools Search this Thread
Special Forums News, Links, Events and Announcements UNIX and Linux RSS News Novell Responds to SCO's Objections to its Bill of Costs
# 1  
Old 09-08-2010
Novell Responds to SCO's Objections to its Bill of Costs

Novell has responded to SCO's Objections to Novell's Bill of Costs for the two trials. Novell did not fail to notice and point out to the court SCO's cheeky move, asking that the court deny the entire bill, when some of it was costs from the first Utah trial that had already been authorized by the court:
SCO objects to $2,914.74 in costs for folders and binders, which were part of the copy costs. Rather than further dispute entitlement to such costs, Novell withdraws its request for them. However, SCO's assertion that because Novell failed to disaggregate these costs, the Court should "deny Novell's Bill of Costs in its entirety," is absurd. (Objections to Bill of Costs at 7.) Novell's Bill of Costs contains several entries that are not even addressed in SCO's Objections, not the least of which is $99,639.09 in costs that were previously awarded by the Court following the initial bench trial and simply have never been paid by SCO.
After the first trial, SCO objected to Novell's Bill of Costs, got it reduced, and then, despite the court ordering SCO to pay it, never did so. Now they ask that the court toss the bill overboard. Like I say, cheeky. I'm a little shocked that SCO's Chapter 11 Trustee Edward Cahn would allow such a request. SCO seems to show no sense of honor at all about its debts.

More...
Login or Register to Ask a Question

Previous Thread | Next Thread
Login or Register to Ask a Question
IPX_CMD(8)						      System Manager's Manual							IPX_CMD(8)

NAME
ipx_cmd - bridge between Novell's SCMD driver and local IPX network SYNOPSIS
ipx_cmd -A server name [ -l local interface name ] DESCRIPTION
ipx_cmd moves packets from tapN to server and vice versa. It is something like IPX Tunnel, but it uses Novell Netware 5 server Compatibil- ity Mode Driver (AKA Migration Agent) on the other end of wire. You must first configure your kernel tapN device with IPX EthernetII frame and with network number set up on server (you can use kernel autodetection). OPTIONS
-A server name This is IP name of compatibility mode server. You can use DNS name or dotted quad to specify server address. -l local interface name This allows you to specify, which of your IP addresses should be used as IP address of client side of CMD driver. You must configure your tapN device with hardware address 7E:01:AA:BB:CC:DD, where AA:BB:CC:DD is your IP address in hexa. EXAMPLE
If you are on server platan.vc.cvut.cz (147.32.240.81) and your migration agent runs on server boris.vc.cvut.cz, you can configure your system with: insmod ethertap ifconfig tap0 hw ether 7E:01:93:20:F0:51 up ipx_interface add -p tap0 EtherII ipx_cmd -A boris.vc.cvut.cz -l 147.32.240.81 & BUGS
This program was written to satisfy my own needs and should be really improved. At least it should configure tap interface itself. AUTHOR
Petr Vandrovec <vandrove@vc.cvut.cz> ipx_cmd IPX Utilities IPX_CMD(8)