llc2_config(1) User Commands llc2_config(1)
NAME
llc2_config - configure LLC2 interface parameters
SYNOPSIS
/usr/lib/llc2/llc2_config [-P | -U | -d | -q | -i ppa | -r ppa]
DESCRIPTION
The llc2_config utility is used to start/stop the LLC2 subsystem and to configure LLC2 interface parameters.
OPTIONS
The following options are supported:
-d Turns on debug mode. Extra debugging information will be printed out.
-i ppa Initializes the corresponding interface using the file /etc/llc2/default/llc2.ppa.
-P Reads in all /etc/llc2/default/llc2.* configuration files, opens those devices defined in the files, and sets up the streams
needed for LLC2 to use those devices. Before doing this, llc2_config -q will not show anything.
-q Queries the LLC2 subsystem. Information similar to the following example will be printed out for all PPAs (Physical Point of
Attachment) available under the LLC2 module:
PPA State ID MACAddr Type MaxSDU MinSDU Mode
0 up 0000 0800208a217e ethernet 1500 0 3
The fields displayed are described below:
PPA The relative logical position of the interface.
State The state of the interface:
up The interface is initialized and operational.
down The interface was "discovered" by the LLC2 driver, has passed its bootup diagnostics, and is awaiting
initialization.
bad The interface is known to the LLC2 driver, but failed one or more of the integrity checks performed at
boot time. This might include detecting Interrupt Request and shared memory conflicts or failures
detected during the execution of the level 0 diagnostics.
ID The interface ID.
MACAddr The MAC address currently in effect for the interface.
Type The MAC type. Current types supported include:
csma/cd 10 Megabit Ethernet
ethernet Ethernet type device
tkn-ring 4/16 Megabit Token Ring
fddi 100 Megabit Fiber Distributed Data Interface
MaxSDU The Maximum Service Data Unit size transmitted on this interface.
Mode The Service Modes supported by this interface. This field consists of the bitwise logical-ORing of the supported
modes, also defined in /usr/include/sys/dlpi.h.
-r ppa Uninitializes the corresponding interface. By using this option, and then using the -i option, the parameters associated with an
interface can be changed.
-U Destroys all streams used by the LLC2 subsystem. This is the reverse of the -P option. After this is executed, llc2_config -q
will not show anything.
FILES
/etc/llc2/default/llc2.* LLC2 configuration files
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
+-----------------------------+-----------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+-----------------------------+-----------------------------+
|Availability |SUNWllc |
+-----------------------------+-----------------------------+
SEE ALSO
llc2_autoconfig(1), llc2(4), attributes(5), llc2(7D)
SunOS 5.10 18 May 1999 llc2_config(1)