USB to Serial Adapter connection

10 More Discussions You Might Find Interesting

1. Linux

Connect from USB to serial port of switch

I have someone wanting to connect to the serial management port of a switch from a PC running CentOS6. The management port on the switch is apparently baud 9600, 8 data bits, 1 stop bit & no parity They have plugged in a cable to connect and the output from lsusb is:-Bus 001 Device 001: ID...

2. Solaris

Solaris 11.2 does not assign serial port to 3g usb modem?

In ubuntu etopic i create this udev rules for prolink 3g usb modem: SUBSYSTEM=="block", SUBSYSTEM=="scsi", ATTRS{idVendor}=="1e0e", ATTRS{idProduct}=="f000", ACTION=="add", RUN+="/sbin/modprobe usbserial Vendor=0X1e0e Product=0Xf000" After plugging the usb modem, ubuntu assigns the ports...

3. Hardware

How to install a driver of my USB-A to Serial Cable

Hi Gurus of Unix Recently I install a OpenSolaris in My HP 530 In this moment want to install a USB-A to Serial Cable. Any guru can send a Link where I can use how reference. I want to configure a Router and my PC don't have any serial Port. My LapTOP only has USB ports. In this case I buy a...

4. Solaris

Detecting wirelss USB Adapter

Hi, i try to plug in my USB wireless adapter to my sun solaris server. However, it cannot detect it. How do i set it so that it can detect it?

5. IP Networking

my wireless usb adapter connect to net but the signal is very weak

i have wireless usb adapter rtl8187 from micromax company my proplem is the signal is very weak and i cannot open website can i increase the signal ? iwconfig lo no wireless extensions. eth0 no wireless extensions. wmaster0 no wireless extensions. wlan0...

6. UNIX for Dummies Questions & Answers

USB serial help needed

Hi iam new bie to unix. we are getting the sensor positional values on hyperterminal(UART).but our task is to use this data for mouse movement.so wat we hav to do ?? is this required to change usb driver cud u send info regarding my query?? Thanks in advance :) :) :)

7. Solaris

Usb to serial connection to Sun Enterprice 450

Hi all, I must connect my PC (Windows 2000) to Sun Enterprise 450 (4 X UltraSPARC-II 400Mhz) for Solaris 10 Installation. My PC doesn't have a serial port therefore I must use USB port. How can I connect USB port of my PC to the serial port (DB 25) of Sun 450? Will be there any problems with...

8. SCO

Usb To Serial (sco6)

According to sco6 usb supplement, once you install it, you can install a bafo industries (BF-810) in the computer. I have done all that and followed the intructions completely and it shows up using usbprobe and l /dev/usb_ser* Problem is that when I go to mkdev serial, it is not there. Anyone...

9. UNIX for Dummies Questions & Answers

isa serial port adapter card no longer detectedworking

hi all, i've got an old PC with unix (SCO System V/386 rel. 3.2) on it. Pentium I; 128mb; ISA 2-port RS232 serial adapter card for an oki dot-matrix printer. (no usb, no CD) i've been running an old cobol program to do some invoicing and print reports. some time back i changed the...

10. Linux

modem - usb to serial configuration

I have a serial modem connected to a usb port using an adapter cable. The system is a HP DL360. RedHat ES3.0 I am using the device /dev/ttyUSB0 When I issue the command "mgetty ttyUSB0" I get the following output in the log file. How do I get the system to see the modem. 12/02 14:17:55...

LEARN ABOUT DEBIAN

uplcom

UPLCOM(4)						   BSD Kernel Interfaces Manual 						 UPLCOM(4)

NAME

     uplcom -- USB support for Prolific PL-2303/2303X/2303HX serial adapters driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device uplcom
	   device ucom

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   uplcom_load="YES"

DESCRIPTION

     The uplcom driver provides support for various serial adapters based on the Prolific PL-2303, PL-2303X and PL-2303HX USB-to-RS232 Bridge
     chips.

     The device is accessed through the ucom(4) driver which makes it behave like a tty(4).

HARDWARE

     The uplcom driver supports the following adapters:

     o	 ATEN UC-232A
     o	 BAFO BF-800
     o	 BAFO BF-810
     o	 Belkin F5U257
     o	 ELECOM UC-SGT
     o	 HAL Corporation Crossam2+USB IR commander
     o	 Hama USB RS-232 Serial Adapter
     o	 Hamlet exagerate XURS232
     o	 IOGEAR UC-232A
     o	 I/O DATA USB-RSAQ
     o	 I/O DATA USB-RSAQ2
     o	 I/O DATA USB-RSAQ3
     o	 Mobile Action MA-620 Infrared Adapter
     o	 PLANEX USB-RS232 URS-03
     o	 RATOC REX-USB60
     o	 Radio Shack USB Serial Cable
     o	 Sandberg USB to Serial Link (model number 133-08)
     o	 SOURCENEXT KeikaiDenwa 8 (with and without charger)
     o	 Sony Ericsson USB Cable (Susteen USB Data Cable)
     o	 Willcom W-SIM DD PHS terminal.(WS002IN)

SEE ALSO

     tty(4), ucom(4), usb(4)

HISTORY

     The uplcom driver appeared in NetBSD 1.6.	This manual page was adopted from NetBSD by Tom Rhodes <trhodes@FreeBSD.org> in April 2002.

BSD
								 November 22, 2006							       BSD

Solaris