You should have a device corresponding to the full root disk, not the fdisk partition in it. I don't have a machine to hand to check the device name format, but will post back in a couple of hours.
ok, you should have a device with almost the same name as you root disk, but ending in p0. eg c0t0d0p0 or maybe c0t0p0 (if you have an IDE drive), thats the one you want.
In my case I only have one partition on the disk using the whole disk
Type 1 to create a partition
Choose Solaris2 as the partition type
Then specify what % of the disk you want to use
Select 5 to write the changes to the disk
It is probably best to reboot the system after this to ensure that the disk state is saved and stable.
After reboot:
Then you can use format to create one ore more new slices.
Then newfs the slices and you should be ready to mount and use them.
I am using Solaris 9 (Sparc based) with Sybase and a proprietary DB application that works with Sybase. In the past we have not used SVM or any RAID config. The DBs were configured such that each DB had its own partition.
Now I would like to setup a new machine with the DBs on a RAID5 config... (1 Reply)
I have a solaris 10 system configured using NetApp as its storage, and the file systems are already configured as you can see from the example below:
root@moneta # df -h
Filesystem size used avail capacity Mounted on
/dev/md/dsk/d0 9.8G 513M 9.3G 6% /... (4 Replies)
I have a solaris 10 system configured using NetApp as its storage, and the file systems are already configured as you can see from the example below:
root@moneta # df -h
Filesystem size used avail capacity Mounted on
/dev/md/dsk/d0 9.8G 513M 9.3G 6% /
... (0 Replies)
I’m setting up a boot disk mirror on Solaris 10 x86. I’m used to doing it on SPARC, where you can copy the partition table using fmthard. My x86 boot disk has 2 primary partitions, a Solaris one and a diagnostic one. Is there a way to copy those 2 primary partitions to the second disk without... (6 Replies)
Friends,
I have an 80 GB IDE hard disk on which I installed Solaris 10, the layout being
Total size of the partition being 30 GB
c0d0s0 = / directory = 15 GB
c0d0s1 = swap file system = 1 GB
c0d0s7 = /export/home directory = 1GB
c0d0s8= boot
c0d0s9 = alternates
... (3 Replies)
i have one 9 gb hdd having root 2 gb fs
now i want to create additional 1gb fs in remaining space
unix partation created in entired 9gb
thanx (1 Reply)
Hello
I wonder if someone could help me in reading a raw (non-Solaris) disk on a Solaris system...
I have an IDE HDD in my Sun Blade and would like to read it (using C). It appears on the system and with the format command shows up as c0t1d0.
I use the dd command to read the disk as such:... (19 Replies)
Hi all!
Working on Oracle v8.1.7.0.0 with OS as Suse v8.0 Linux.
I had created LVM,linked raw devices to LVM as below:
# for binding raw devices
raw /dev/raw/raw1 /dev/oracle/sam_raw_system_251m
raw /dev/raw/raw2 /dev/oracle/sam_raw_users_26m
raw /dev/raw/raw3... (2 Replies)