6 More Discussions You Might Find Interesting
1. Infrastructure Monitoring
Hi Folks,
realise that this forum might not be the exact match for this question, so feel free to put it somewhere more apropriate.
I'm currently involved in a project that has gone somewhat pear shaped, just to keep this all short the situation is as follows. I was brought in to manage a... (2 Replies)
Discussion started by: gull04
2 Replies
2. Red Hat
Installed the iscsi target and configured its working fine
While i'm running command in initiator
# iscsiadm --mode discoverydb --type sendtargets --portal 192.168.1.5 --discover
iscsiadm: No portals found
i cant find the LUN1 , its not discovering it what may be the issue and how to... (0 Replies)
Discussion started by: babinlonston
0 Replies
3. AIX
Hi all,
i must add a new disk on a LPAR.
I've done all the HMC and VIOS Procedure to create a virtual host with disk and assign it to lpar.
I don't remember how i must do on the lpar to see this disk. (i use lvm not veritas).
Thanks in advance and sorry for my english.
Bye
Mario (2 Replies)
Discussion started by: Zio Bill
2 Replies
4. AIX
Hi All,
i would like to know if it's possible to know all the IP Addresses of all LPAR's interfaces from HMC (without connect into LPAR).
And if i can know also the "Application" hostname of LPAR from HMC.
Thanks in advance.
Bye
Mario (2 Replies)
Discussion started by: Zio Bill
2 Replies
5. UNIX for Dummies Questions & Answers
Hello All!
New Unix admin here, with a bit of a problem I can't seem to get a straight answer to..
I've been tasked with mapping out the topology (with IPs/Hostnames) of networks...remotely. So, I have SSH access to firewalls, but that's about as far as I can get - how would I go about... (4 Replies)
Discussion started by: Tiyugro
4 Replies
6. Shell Programming and Scripting
I am trying to make a bash script to scan subnets to see what hosts are available. Is it correct that you can not make the ping command time out less than a second? The script below works, but can take up to 255 seconds which is a bit long :( Is there a way to solve this using bash only?
<code>... (6 Replies)
Discussion started by: bronkeydain
6 Replies